User manual AEG-ELECTROLUX EFA9673AS

[. . . ] Electrolux Welcome to the world of Electrolux Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples on the cover in this manual. Please take a few minutes to study this manual so that you can take advantage of the benefits of your new machine. [. . . ] This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery , the hood is not supplied Y), with a charcoal filter(EFA 9673 ONLY) EFA ONLY) EF so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Set in "OFF the hood. oFF" OFF Press buttons 3 and 4 simultaneously and hold them for 3 seconds. At first only the grease filter LED F will light up, but when the charcoal filter LED C lights up the saturation indicator will be enabled. To disable it: Press buttons 3 and 4 again simultaneously and hold them for 3 seconds, until the charcoal filter LED goes out. Grease filter LED (F) LED F will start to flash when it is time to clean the grease filter. Cleaning will be necessary after 40 working hours. Always comply with the maintenance instructions for the grease filter. Charcoal filter LED (C) The charcoal filter LED C will start to flash when the charcoal filter needs to be replaced. This operation is necessary after approximately 160 working hours. Resetting the saturation indicator After cleaning or replacing the filters, press button 3 for 3 seconds until the grease filter LED F or the charcoal filter LED C stops flashing. Before performing any maintenance operation, isolate the hood from the off removing electrical supply by switching off at the connector and removing the connector fuse. Through Or if the appliance has been connected through a plug and socket, then the removed from plug must be removed from the socket. The perimeter air suction panels are attached to the cooker hood by a series of pins and coupling springs springs; pull them outwards and detach them from the fastening cable cable. Clean the perimeter air suction panels as often as the grease filters (for more information about gentle cleaning methods, read the paragraph "Cleaning" in the pages that follow). Make sure the panels are attached to the cooker hood properly (snapfastened). The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Hand washing Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. dishwasher Place grease filters in the dishwasher. [. . . ] Fix the cooker hood to the structural support using 16 screws (4 per bracket). Place the template on the ceiling directly above the hob (the centre and sides of the template should be aligned with the centre and sides of the hob). Note: The side displaying the text "FRONT" corresponds to the side which will house the control panel once installation is complete. Make the holes as indicated on the template (6 holes for 6 screw anchors) and partially tighten 4 screws into the screw anchors in the corners (leave approximately 1 cm between the head of the screw and the ceiling). [. . . ]