User manual AEG-ELECTROLUX EFA9780-1X

[. . . ] Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flambè under the range hood; risk of fire · The hood should not be used by children or persons not instructed in its correct use. maintenance · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. [. . . ] Use a plumb line to mark the centre of the hob on the ceiling/support shelf. Place the drilling template 21 provided on the ceiling/support shelf, making sure that the template is in the correct position by lining up the axes of the template with those of the hob. For wooden beam ceilings, drill according to the wood screws used. For the power supply cable feed, drill ø 10 mm. Insert two screws of the following type, crossing them and leaving 4-5 mm from the ceiling: · For concrete ceilings, use the appropriate plugs for the screw size (not provided). For Cavity ceiling with inner space, with wall thickness of approx. For wooden beam ceilings, use 4 wood screws (not provided). For wooden shelf, use 4 screws 12g with washers 22 and nuts 23, provided. Loosen the two screws fastening the lower chimney and remove this from the lower frame. Loosen the two screws fastening the upper chimney and remove this from the upper frame. Insert the upper chimney stack from above, and leave it running free on the frame. In courtesy light mode the touch control is not lit. T1 When pressed the motor is stopped, regardless of the speed it is set to. Indicator lights Touch control unlit Touch control lit Lights off Lights on Motor on Motor off Touch control lit Second speed on Delay function on When pressed the motor is set to the first speed By a brief pressing the motor is set to the second Touch control lit speed. By pressing the touch control for approximately Flashing touch 2 seconds the Delay function is enabled, i. e control delayed shutdown of the appliance ensuring a complete elimination of the residual odours. This function can be activated at OFF-position and at 1°, 2° and 3°speeds. It can be stopped in advance by pressing any of the touch controls (T) with the exception of T3. The Delay function works according to the following scheme: 1°speed / OFF = 20 minuets 2°speed = 15 minutes 3°speed = 5 minutes When pressed the motor is set to the third speed When pressed the motor is set to the intensive speed timed to 5 minutes. At the end of 5 minutes of intensive speed the hood starts again at the speed it was set to previously. In case the hood is set to the intensive speed directly from OFF-state it will then start from the first speed after 5 minutes of intensive speed. When pressed for 4 seconds it resets the filter alarm signal indicated by flashing of the touch control T1. [. . . ] Any kind of bending of the filters has to be avoided when washing them. Before fitting them again into the hood make sure that they are completely dry. When fitting the filters into the hood pay attention that they are mounted in correct position and that the handle faces outwards. This filter cannot be washed or regenerated, and must be replaced when the F touch control starts to flash, or at least once every 4 months. [. . . ]