User manual AEG-ELECTROLUX EFC008X

[. . . ] Therefore you should read through instructions, advises and safety instructions carefully before you install and start using the cooker hood. Pay special attention to sentences with a warning triangle to avoid damages to person or property. Save the instruction boook for future reference if the cooker hood is sold or left to another person. Installation and service · Any electrical installation of the cooker hood must be carried out by a qualified electrician and the hood itself must be installed by someone with experience. Installation made by an unqualified person can lead to loss of function of the cooker hood and possible damage to person and/or property. [. . . ] To disconnect the warning signal, press the buttons B and G at the same time for about 3 seconds until the LED marked C goes out. O 1 2 F 3 C O I A B EF CD G H I 3 Grease filter saturation led The LED marked F warns you when the grease filter needs to be cleaned. This LED flashes to warn you that the grease filters must be cleaned. Generally, these must be cleaned after 40 hours of use. Read the maintenance instructions provided for the grease filters. Carbon filter saturation led The LED marked C indicates carbon filter needs to be replaced. This must be done after approximately 160 hours of use. Read the instructions provided for replacing the carbon filter. To restore the LED for the filter warnings. After cleaning of the grease filter and exchange of the carbon filter, press button A for about 3 seconds until the LED F stops flashing. Correct ventilation If the cooker hood should be working correctly there must be an underpressure in the kitchen. It is important to keep the kitchen windows closed and have a window in an adjacent room open. Important to know Not applicable for recirculation. Great care must be taken if the hood is used at the same time as a burner or fireplace (e. g. gas, diesel, coal or wood heaters, water heaters, etc. ), as the hood will expel air which is required by these other appliances. The negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. 4 Maintenance and cleaning Before doing any maintenance work on the hood, disconnect it from the main supply by disconnecting the plug from the wall socket or unscrewing the fuse. The grease that collects in the filter and the duct could ignite if a hot plate is left on (or if overheating occurs). Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products. Cleaning the grease filters Clean the filter every month or every other month according to how much the hood is used. The cleaner the filters, the better it collects grease. 3): · Push the handle towards the rear of the hood. · Pull the filter down at the front and remove it forwards. The filter is made of aluminium wires on which the grease collects. Clean the filter in hot water using a detergent, or in a dishwasher. Let the filter dry before putting it back. Note that a dishwasher may discolour the filter. a b Fig. 3 Changing the carbon filter Only applicable for recirculation. [. . . ] Fit the template supplied on the ceiling vertically to the centre of the cooktop (the short sides of the template correspond to the long side of the hood-to consider when drilling). Drill asindicatedandinsert 4wallplugs, screw onit4screws, do not thighten completely, screws will serve to hang the hood. 10. 4 3 8 4 6 5 10 10 10 7 5 9 5 6 7 5 10 6 9 (Umluftbetrieb!) (Recirculation!) Fig. Hang the structure complex and with a pencil mark 2 fixing points corresponding to wall plugs 6. [. . . ]