User manual AEG-ELECTROLUX EFC1436X/S

[. . . ] Instruktionsbok, Bruksanvisning, Brugsvejledning EFCR 143 EFC 1436 Käyttöohje, User Manual, Gebrauchsanweisung S N DK FIN UK D S N DK FIN UK D Innehållsförteckning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Innholdsfortegnelse . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Indholdsfortegnelse . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Sisällysluettelo . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] It is, for example, opportune to use intensive speed to evacuate odours after finishing cooking. If the hood or the commands are not working, disconnect the electricity supply for at least 5 minutes and start the apparatus again. G H I Activate the LED as indicated below if the hood has to be used with the carbon filter: Press keys B and G simultaneously for three seconds. The D anti-fat filter LED lights up and then the E carbon filter LED as well. At this point the LED that signals the saturation of the active carbon filter has been activated. Press keys B and G simultaneously for three seconds until the E carbon filter LED switches off. Grease filter LED (D) The D LED begins to flash when the anti-fat filter needs to be washed. The anti-fat filter must be changed after about 40 hours of use. Follow the instructions for changing the anti-fat filter. The active carbon filter LED (E) The E LED begins to flash when the active carbon filter must be changed. The anti-fat filter must be changed after about 160 hours of use. Follow the instructions for changing the active carbon filter. Restoring the saturation indicator After having carried out maintenance on the filter, keep key A held for 3 seconds until the LED of the anti-fat filter D or the LED of the carbon filter E stops flashing Attention!Restoring the saturation indicators MUST be carried out with the hood set in Standby and therefore without disconnecting the hood from the power supply. Correct ventilation A vacuum must be created in the kitchen for the correct functioning of the hood. It is important to keep the kitchen windows closed and have a window open in an adjacent room. Important If the hood is used together, for example, with an open fireplace that takes air from inside the house, a draught might occur that could bring fumes into the room. This does not concern the active carbon filter version. Do not use the hood at an excessive speed. The lower speeds are sufficient for normal cooking. Control device of the saturation of the grease and active carbon filters. The aspiration hood is equipped with a device that signals when the grease or active carbon filter (recirculation with carbon filter version) needs cleaning. The hood is delivered from the factory without the carbon filter and therefore the LED that signals filter saturation is inactive. 41 Maintenance and cleaning Disconnect the hood from the power before any maintenance work, removing the plug or the fuse. Deposits of fat on the filter and the sides of the evacuation conduit are a fire danger if, for example, a ring has been forgotten and inadvertently left on (or in the case of other kinds of overheating). Cleaning the hood Clean the exterior of the hood with a damp cloth and a neutral detergent. Never use cleaning products containing corrosive and abrasive, agents or inflammable substances. Cleaning the grease filter Clean the anti-fat filter every month or every two months, according to how long the hood is used. The more often the filter is cleaned, the more often will it be able to retain the fats. To remove the filters Fig. 4: · Press the clip on the metal grease filter backwards and remove the filter downwards. [. . . ] 13 Mounting the anti-fat filter Position the filter at the back of the hood and move the handle upwards until the filter is blocked. Fig. 14 46 Connection to external motor Valid only for the EFCR 143 model. The hood is not equipped with an internal motor and must be connected to an external motor (to purchase separately). The electrical connection must be carried out with the help of suitable connections. [. . . ]