User manual AEG-ELECTROLUX EFC60420X

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. use · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has ben designed. [. . . ] Repeat this operation on the other side. Insert the two screws 12a (4, 2 x 44, 4) supplied in the hood body fixing holes, leaving a gap of 5-6 mm between the wall and the head of the screw. Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points. Adjust screws Vr to level the hood body When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the pipe in position using sufficient pipe clamps (not supplied). Make sure that the outlet of the extension pieces 14. Connect the air outlet connection 15 to the hood body outlet using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Slightly widen the two sides of the upper flue and hook them behind the brackets 7. 1, making sure that they are well seated. Make sure that the outlet of the extensions pieces is aligned with the chimney outlets. lowerexhaustflue · Slightly widen the two sides of the flue and hook them between the upper flue and the wall, making sure that they are well seated. Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. [. . . ] It must be replaced when led S1 flashes or at least every 4 months. The alarm signal will only light up EN when the extractor motor is switched on. Disconnect the Hood using the Main switch or the double-pole switch on the mains power supply. [. . . ]