User manual AEG-ELECTROLUX EFC634W

[. . . ] · Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. · For Class I appliances, check that the domestic power supply guarantees adequate earthing. Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. The route of the flue must be as short as possible. [. . . ] · Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc. ). · If the extractor is used in conjunction with non-electrical appliances (e. g. gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. Use · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. · Never use the hood for purposes other than for which it has ben designed. · Never leave high naked flames under the hood when it is in operation. · Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. · Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. · Do not flambè under the range hood; risk of fire · The hood should not be used by children or persons not instructed in its correct use. WARNING: It is a possible fire hazard if the metal grease filters are not cleaned and the charcoal filters replaced regularly. ø120 G ø125 F G ø150 EN H B A Connection to the Mains WARNING: Double insulated do not earth · Before connecting to the mains supply ensure the mains voltage corresponds to the voltage on the rating plate inside the hood. · This appliance is fitted with a 2 core mains cable and must be permanently connected to the electricity supply via a double-pole switch having 3mm minimum contact gap on each pole. 8 electrolux Installation/Use Chimney assembly Upper Chimney · To fit the upper chimney A, place the top edge of the chimney over the EN bracket C as illustrated and secure the chimney using two of the 2. 9mm self tapping screws provided. · The distance H in the height between the fixing holes X1 and X2 is determined by the height of the upper chimney A. Lower Chimney · To fit the lower chimney B, apply slight force to the two rear edges to increase the width of the apperture, then sleeve the chimney B over the chimney A as illustrated. B USE The cooker hood functions are controlled by a series of slider or push button switches mounted on the front of the hood and control the worktop lighting and fan motor speeds. 1) SLIDER SWITCHES - A switch controls the wotktop lighting - ON/OFF. - A switch controls the fan speeds OFF/ON-1-2-3. - The red neon lamp illuminates when the motor is switched ON . 2) SPEED SETTINGS - 1/Low should be selected when simmering or when using only one pan. - 2/Medium should be selected for cooking when using up to four pans. - 3/High should be selected when frying or cooking food with a strong odour. S30_08_n Maintenance electrolux 9 MAINTENANCE N. B. [. . . ] - 2/Medium should be selected for cooking when using up to four pans. - 3/High should be selected when frying or cooking food with a strong odour. S30_08_n Maintenance electrolux 9 MAINTENANCE N. B. Before carring out any kind of maintenance, cleaning or replacing lamps, disconnect the hood from the mains supply. Lighting 40 W incandescent light · Remove the metal grease filters. [. . . ]