User manual AEG-ELECTROLUX EFC639X-ELC03

[. . . ] Gebrauchsanweisung, Libro de Instrucciones, Manuel d'utilisation EFC 939 X EFC 639 X Istruzioni per l'uso, User Manual D E F I UK Contents Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41 Description of the appliance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42 Mounting of grease filters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42 Function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Disconnect the power plug and cut the power cord at hood inlet. Check with the authorities for information of how to proceed for disposal. Description of the appliance 1. Grease filters Standard accessories included: l Screws for mounting l Template for wall mounting l No return valve (mounted on air outlet) EFC 639 1 2 3 Mounting of grease filters Attention!The grease filters are supplied not mounted and packed in order to avoid damages during transport of the hood. l Fit the pins of the filter on the slots of the grease filter housing, then use the handles of the filter to lock them. l Pull the handles backwards to loosen the filter (Fig. 1). EFC 939 1 2 3 Function The hood may be used as follows: - Exhausting version - Recycling version Fig. 1 Exhausting version The air is vented outdoors by a 150 mm duct which must be connected to connecting ring with no return valve on top of the motor package. The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. Please, keep to the provisions of official directives regarding the question of fumes discharge. Recycling version The air is filtered through a carbon filter and recirculated into the room through the top sides of the chimney (Fig. This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. Fig. 2 42 Special accessories Active carbon filter When the hood is used in recirculation mode an active carbon filter should be used. Order by the retailer: PNC 942 120 182 Installation Unpacking Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller. Take care of the packing material so that small children cannot play with it. Placement The hood is to be mounted on the wall. When installed, the hood must be not less than 65 cm. 3). Min 65 cm Min 75 cm Electrical connection The hood has a power cord with moulded plug with earth connection to be connected to a wall outlet of 230 V. The power outlet should be pre-mounted in such a way that the power cord is invisible when the hood is fully mounted. As it is then hard to disconnect the power plug for cleaning and service, an easy accessible two pole switch should be fitted. The switch should conform to regulations with an opening distance between contacts of not less than 3 mm. Fig. 3 43 Mounting of hood l Fit the drilling scheme onto the wall at the right height. 4) The lower edge of the scheme correspond to the lower edge of the cooker hood. [. . . ] This LED flashes to warn you that the grease filters must be cleaned. Generally, these must be cleaned after 40 hours of use. Read the maintenance instructions provided for the grease filters. Carbon filter saturation led The LED marked C indicates carbon filter needs to be replaced. This must be done after approximately 160 hours of use. [. . . ]