User manual AEG-ELECTROLUX EFC90131X

[. . . ] The hood must NEVER be used as a support surface unless specifically indicated. The premises must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. The suctioned air must not be conveyed into a conduit used for the disposal of the fumes generated by appliances that combust gases or other fuels. the flaming of foods beneath the hood itself is severely prohibited. [. . . ] Before performing any maintenance operation, isolate the hood from the off removing electrical supply by switching off at the connector and removing the connector fuse. Through Or if the appliance has been connected through a plug and socket, then the removed from plug must be removed from the socket. grease Metal grease filter · The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Hand washing Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). The charcoal filter should only be used if you want to use the hood in recirculation mode. To do this you will need an original charcoal filter (available from your local Service Force Centre). The charcoal filter cannot be washed nor regenerated. The charcoal filter should be replaced every 4 months under normal use. Replacement filters are available from your local Service Force Centre. Align the pins R on the cowl with the S, slots S then turn the filter clockwise until it locks in place. Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. The charcoal filter can be ordered from your local Service Force Centre. [. . . ] Do not connect the appliance to the mains until the installation is fully complete. Using the template supplied, mark the holes, drill them and insert the dowels, partly tighten 1 screw in the top dowel. Bearing in mind the minimum heights over the cooktop specified above, mark the height of the hood on the wall with a pencil and place the template against the wall on the mark. Fix the flue support to the wall as close as possible to the ceiling. [. . . ]