User manual AEG-ELECTROLUX EFC90445X

[. . . ] Fuse grounded socket outlet preferably direct in the connection box. Electrical data are found inside the apparatus on the type plate after opening the grease collecting pan (12) behind the steel filter (15). Before opening, disconnect the device form the mains power supply by turning off main switch (17). Connection and putting in operation may only be carried out by a professional electrician. [. . . ] Take the wall fixing rail off from the rear side of the hood by unscrewing the three screws on the topside of the hood. Now fasten the wall fixing rail using five 5 x 50 mm round-head screws from the by-pack kit. For the cable suspension you have to copy two drill holes onto the ceiling. Now drill the two 10 mm holes into the ceiling. Now take the two dowels and the two hanger bolts out of out of the by-pack kit and place them into the two holes. Screw the two cover discs from the by-pack kit onto the hanger bolts. Thread-in the cable suspension together with the cable tightener into the hood body from the top. Screw in the cable tensioner into the retainer and lock it by tightening the headless screw. Now hang in the hood body into the wall fixing rail. Now screw the two cable suspensions together with the cable retainers onto the hanger bolts. In doing so the steel cable may twist, however it will unstring again during workstep 15. After this treatment seal again with care lotion (as described above). On stainless steel devices, it is imperative to observe the "brush direction"!Cleaning the inside: Before opening it is imperative to disconnect the device form the mains power supply by turning off main switch (17)!When exchanging activated carbon fleece / activated carbon respectively when cleaning the metal grease filters (7/15), clean accessible enclosure parts from grease deposits. This is to prevent a fire hazard and optimum functioning is maintained. Please only clean using a grease-dissolving dishwashing detergent or the grease remover included in the scope of delivery and a moist cloth. Filters: Caution! With increasing saturation by greasy deposits flammability increases and functioning of the device may be impaired. Clean metal filters (7/15) in due time ! Before cleaning it is imperative to remove the activated carbon attachment and knurled screws!At normal operating conditions (2 to 3 hours daily), the metal grease filter (7/15) needs to be cleaned every 8 to 10 weeks. Cleaning should be done using the cleaning agent, which is attached to the exhaust hood, however cleaning the filters can also be done in the dishwasher, depending on size. The cleaning intervals for the metal filters (7) on top of the hood body shorten in the pollen-rich season. [. . . ] When crackling continues persistently, the upper metal filters and the ionize sheet must be cleaned. Furthermore you should check if the connector of the supply cable is connected to the ionizer sheet horizontally. In case of undervoltage it can happen in power step 1 that the interconnecting relay for the ionizer and for the UVC lamp switches on and off several times (flips). You can eliminate this by shortly activating power step 3. [. . . ]