User manual AEG-ELECTROLUX EFC9140X

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. use · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has ben designed. [. . . ] Adjust screws Vr to level the hood body When installing the ducting version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 125 mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the pipe in position using sufficient pipe clamps (not supplied). Make sure that the outlet of the extension pieces 14. Connect the air outlet connection 15 to the hood body outlet using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Slightly widen the two sides of the upper flue and hook them behind the brackets 7. 1, making sure that they are well seated. Make sure that the outlet of the extensions pieces is aligned with the chimney outlets. lower exhaust flue · Slightly widen the two sides of the flue and hook them between the upper flue and the wall, making sure that they are well seated. Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button EN When pressed for 2 seconds it starts the lighting system in "courtesy light" mode. The lamps are fed at a reduced power of approximately 5W. Such function can be stopped by pressing the touch control for 2 seconds or just by pressing it shortly in order to return to the normal lighting mode. In courtesy light mode the touch control is not lit. T1 When pressed the motor is stopped, regardless of the speed it is set to. [. . . ] The alarm is only triggered when the motor is on. Disconnect the mains power supply to the hood by removing the motor unit power supply cable connector, switching off the power supply at the Mains or turning the Main switch off. Release the touch control, touch controls L, T2 and F will light up normally. [. . . ]