User manual AEG-ELECTROLUX EFC915X/CH

[. . . ] Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flambè under the range hood; risk of fire · The hood should not be used by children or persons not instructed in its correct use. maintenance · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. [. . . ] maintenance · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Clean and/or replace the Filters after the specified time period. Clean the hood using a damp cloth and a neutral liquid detergent. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. Draw a horizontal line at 650 mm above the hob. 1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre (notch) with the vertical reference line. After 10 minutes of functioning it turns off automatically. This function can be inter-rupted by means of pressing any of the buttons. indicates that the Metal grease filters saturation alarm has been triggered , and the filters need to be washed. The alarm is triggered after 100 working hours. (Reset; check the Maintenance-paragraph) indicates that the activated charcoal odour filter satura-tion alarm has been triggered , and the filter has to be replaced; the metal grease filters must also be washed. The activated charcoal odour filter is triggered after 200 working hours. Switch off the lights and extractor motor. Press button T3 for at least 3 seconds, until the leds T1 and T4 start to flash. cleaningthefilters · The filters are washable and must be cleaned when the LED S1 lights up or at least every 2 months of operation, or more frequently for particularly heavy usage. Remove the filters one at a time holding them up with one hand and pulling the handle downwards with the other hand at the same time. [. . . ] cleaningthefilters · The filters are washable and must be cleaned when the LED S1 lights up or at least every 2 months of operation, or more frequently for particularly heavy usage. Remove the filters one at a time holding them up with one hand and pulling the handle downwards with the other hand at the same time. Wash the filters, taking care not to bend them. When refitting the filters, make sure that the handle is visible on the outside. [. . . ]