User manual AEG-ELECTROLUX EFC929X/KO

[. . . ] Therefore you should read through instructions, advises and safety instructions carefully before you install and start using the cooker hood. Pay special attention to sentences with a warning triangle to avoid damages to person or property. Save the instruction boook for future reference if the cooker hood is sold or left to another person. Installation and service · Any electrical installation of the cooker hood must be carried out by a qualified electrician and the hood itself must be installed by someone with experience. Installation made by an unqualified person can lead to loss of function of the cooker hood and possible damage to person and/or property. [. . . ] Great care must be taken if the hood is used at the same time as a burner or fireplace (e. g. gas, diesel, coal or wood heaters, water heaters, etc. ), as the hood will expel air which is required by these other appliances. The negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. 4 Maintenance and cleaning Before doing any maintenance work on the hood, disconnect it from the main supply by disconnecting the plug from the wall socket or unscrewing the fuse. The grease that collects in the filter and the duct could ignite if a hot plate is left on (or if overheating occurs). Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products. Cleaning the grease filters Clean the filter every month or every other month according to how much the hood is used. The cleaner the filters, the better it collects grease. 3): · Push the handles towards the centre of the hood · Pull the filter down to remove. The filter is made of aluminium wires on which the grease collects. Clean the filter in hot water using a detergent, or in a dishwasher. Let the filter dry before putting it back. Note that a dishwasher may discolour the filter. Fig. 3 Mounting the carbon filter Only applicable for recirculation. The carbon filters absorb smells and odours. The carbon filter cannot be washed nor regenerated. The carbon filter should be replaced every 6 months under normal use. Ask the technical assistance service or manufacturing company for a new one. After approximately three years of use, the KF2000 filter should be replaced with a new, as the odour reduction capacity will be reduced. 2): · Unplug the unit or disconnect it from the power supply · Remove the metal grease filter. 3 · Fit the carbon filter and fix it to the body of the hood with two supplied screws. · Refit the metal grease filters. To dismount proceed in reverse order. Fig. 4 Changing the light Disconnect the cooker hood from the main supply before changing the light. [. . . ] Use the support bracket as a drilling template (the small slot formed on the support must coincide with the line drawn on the wall as above) and mark 2 holes with a pencil, dril the holes (11 - Ø8mm), insert 2 wall plugs (12). · Fix the chimney support bracket to the wall using two 5x45mm screws (14). · Connect a pipe (pipe and pipe clamps not provided, to be purchased separately) for discharge of fumes to the connection ring located over the suction motor unit (16). If the hood is to be used in ducting version, the other end of the pipe must be connected to a device expelling the fumes to the outside. [. . . ]