User manual AEG-ELECTROLUX EFC935X-A

[. . . ] USE · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. · Never use the hood for purposes other than for which it has ben designed. · Never leave high naked flames under the hood when it is in operation. [. . . ] · Place bracket 7. 1 on the wall as shown, 265 mm above the horizontal reference line, aligning the centre (notch) with the vertical reference line. · Mark the wall at the centres of the holes in the bracket. · Place bracket 7. 2. 1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre (notch) with the vertical reference line. · Mark the wall at the centres of the holes in the bracket. · Place bracket 7. 2. 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. · Mark the wall at the centres of the holes in the bracket. REAR PANEL (OPTIONAL) The Rear Panel must be fitted before fixing the hood body and, for both upper an lower positiion fixing, must be fitted at the correct height prior to installing the bases. As this operation is rather complex, it should be carried out either by the kitchen installer or a qualified person who knows the final dimensions of the units. For the upper fixing position, proceed as follows: · Rest the back panel on the base, inserting the lower plate between the upper surface and the wall, centring it on the vertical reference line. · Mark the centres of the two holes in the upper plate. · Drill ø 8 mm holes at all the centre points marked. · Insert the wall plugs 11 in the holes. · Fix the brackets using the 12a screws (4, 2 x 44, 4) supplied. · Fix the back panel (where present) using the 12a (4, 2 x 44, 4) screws supplied. H 265 7. 1 X 7. 2. 1 EN 6 6 Mounting the hood body · Before hooking up the hood body, adjust the two screws Vr located on the hood body connection points so that they are at the half way point. · Hook the hood body to the mounted bracket. · Adjust the screws Vr to level the hood body. · Tighten the lock screw Vf. Vf Vr Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. · To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. [. . . ] · Remove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. · Wash the filters, taking care not to bend them. · When refitting the filters, make sure that the handle is visible on the outside. Activated charcoal filter (Recirculation version) These filters are not washable and cannot be regenerated, and must be replaced approximately every 4 months of operation, or more frequently with heavy usage. [. . . ]