User manual AEG-ELECTROLUX EFC9360X

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. use · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has ben designed. [. . . ] Make sure that the outlet of the extension pieces 14. Connect the air outlet connection 15 to the hood body outlet using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Slightly widen the two sides of the upper flue and hook them behind the brackets 7. 1, making sure that they are well seated. Make sure that the outlet of the extensions pieces is aligned with the chimney outlets. lower exhaust flue · Slightly widen the two sides of the flue and hook them between the upper flue and the wall, making sure that they are well seated. Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. Function Switches the extractor motor on and off at the latest selected speed Decreases the suction speed. By pressing this key it is possible to start the intensive speed from any previously selected speed except the Delay-function and 24H-function. This function is suitable for cooking conditions when vapours and smells are at the utmost emission. By pressing this key it is possible to set up the motor to a suction speed at 100 m3/h . by pressing this key it is possible to set the delayed shutdown of the motor and the lighting to 30 minutes. This function is suitable for a complete elimination of residual cooking odours. Functioning only when the motor is on(not during the 24H-function or intensive function). By pressing the key the function is stopped By pressing this key for about 2 seconds it is possible to reset the filter saturation alarm By pressing the key the function is stopped By pressing the key the function is stopped After 100 working hours a drop-symbol appears. metal grease filters have to be washed. By pressing this key the intensity of the lighting system can be decreased. [. . . ] In the recycling version hoods the filter saturation alarm must be activated during the instal-lation or later. Press the E-key for about 5 seconds until the last two segments of the motor LEDS are lit on the display. Within 3 seconds press the D-key to activate/deactivate charcoal filter saturation alarm. [. . . ]