User manual AEG-ELECTROLUX EFC9466X/S

[. . . ] Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. The hood should not be used by children or persons not instructed in its correct use. MAINTENANCE Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Clean and/or replace the Filters after the specified time period. [. . . ] Mark a reference point as indicated at 116 mm from the vertical reference line and 330 mm above the horizontal reference line. Repeat this operation on the other side. Drill 8 mm holes at all the centre points marked. Fix the lower bracket 7. 2. 1 using the 12a screws (4, 2 x 44, 4) supplied. Fix the upper bracket 7. 2. 1 and the air outlet connection support 7. 3 together using the 2 screws 12a (4, 2 x 44, 4) supplied. Insert the two screws 12a (4, 2 x 44, 4) supplied in the hood body fixing holes, leaving a gap of 5-6 mm between the wall and the head of the screw. 650 min. 330 X 7. 2. 1 EN 7 7 Mounting the hood body Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points. Hook the hood body onto the screws 12a. Adjust screws Vr to level the hood body. Vr 12a Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe 150 or 120 mm, the choice of which is left to the installer. To install a 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. Fix the pipe in position using sufficient pipe clamps (not supplied). Remove any activated charcoal filters. 150 9 120 RECIRCULATION VERSION AIR OUTLET Put connection 15 into the connection support 7. 3. Metal grease signal indicated by flashing of the touch control T1. This procedure can be carried out only when the The alarm starts up after motor is stopped. Flashing touch control 100 working hours. Charcoal filter has to be replaced and metal grease filters washed. The alarm starts up after 200 working hours. (Activation; check the paragraph "Odour filter") EN 1 11 1 MAINTENANCE Grease filters CLEANING OF THE METAL CASSETTE FILTERS Alarm reset Stop the motor. Press the F -touch control for at least 4 seconds until the T1 -touch control flashes. Cleaning the filters Filters can be washed in the dish machine. They need to be washed every 2 months or even more frequently in case of particularly intensive use of the hood. Remove the filters one by one pushing them towards the back side of the unit and simultaneously pulling downwards. Any kind of bending of the filters has to be avoided when washing them. Before fitting them again into the hood make sure that they are completely dry. [. . . ] Within 3 seconds press the touch control F until the key itself flashes to confirm as follows: 2 flashes Charcoal odour Filter saturation Alarm ENABLED 1 flash - Charcoal odour Filter saturation Alarm DISABLED REPLACING THE CHARCOAL ODOUR FILTER Reset the alarm signal Stop the motor. Press the touch control F for at least 4 seconds, until the touch control T1 flashes. Replace the Filter Remove the metal grease filters. Remove the saturated charcoal filter, turning the fasteners provided. [. . . ]