User manual AEG-ELECTROLUX EFC9506U/S

[. . . ] Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flambè under the range hood; risk of fire · The hood should not be used by children or persons not instructed in its correct use. maintenance · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. [. . . ] Clean and/or replace the Filters after the specified time period. Clean the hood using a damp cloth and a neutral liquid detergent. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. Draw a horizontal line at 650 mm above the hob. 1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre (notch) with the vertical reference line · 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. Mark a reference point as indicated at 116 mm from the vertical reference line and 325 mm above the horizontal reference line. Repeat this operation on the other side. In case the hood is set to the intensive speed directly from OFF-state it will then start from the first speed after 10 minutes of intensive speed. When this led flashes it means that the metal grease filters need to be washed. The alarm starts up after 100 working hours. (Reset; check the paragraph "Metal filter") Charcoal filter saturation alarm. When this led flashes it means that the Charcoal filter has to be replaced and metal grease filters washed. The alarm starts up after 200 working hours. Pay attention that the grill will not accidentaly fall down on the hob. Clean the outside using a damp cloth and neutral liquid detergent. Clean the inside as well using a damp cloth and neutral detergent; do not use wet cloths or sponges, or jets of water; do not use abrasive substances. When the above operation has been completed, hook the grill back to the hood canopy and close it. Press the T1 -touch control for at least 4 seconds until the S3 -led flashes twice. [. . . ] Press the T1 -touch control for at least 4 seconds until the S3 -led flashes twice. It needs to be washed when the S1 led starts to flash, or every 2 months or even more frequently in case of particularly intensive use of the hood. Remove the filter pushing it towards the back side of the unit and simultaneously pulling downwards · Any kind of bending of the filter has to be avoided when washing it. Before fitting it again into the hood make sure that it is completely dry (The colour of the filter surface may change throughout the time but this has no influence to the filter efficiency). [. . . ]