User manual AEG-ELECTROLUX EFC9520X-CH

[. . . ] · Never use the hood for purposes other than for which it has ben designed. · Never leave high naked flames under the hood when it is in operation. · Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. · Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. [. . . ] · To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. · Fix the pipe using the pipe clamps 25 provided. · Remove any activated charcoal filters. 9 ø 150 RECIRCULATION VERSION AIR OUTLET · · · · Insert reducer flange 9 on the extractor outlet. Push fit the extension piece 14 onto the flange. Push fit connector 15 onto the extension piece. Insert extension piece/connector 14. 1 laterally on connector 15. ø 120 15 14. 1 14 9 17 GB Flue assembly - Mounting the hood body · Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. · Fit the lower chimney section onto the frame, holding it in place until the hood body has been fixed in place. Recirculation version · Make sure that the outlet of the extension piece 14. 1 is horizontally and vertically aligned with the chimney outlet. · If this is not the case, remove the lower chimney section and adjust the position by cutting the hood body extension 14 along one of the thinner section channels denoting the pre-fixed lengths, then reassemble as described previously. Before fixing the hood body to the frame: · Remove the grease filters from the hood body. · Remove any activated charcoal filters. · From below, use the 4 screws 12f (M6 x 10) provided to fix the hood body to the frame. · For the recirculation version, locate the directional grill 8 in its housing. Ensure that it is inserted correctly in connector 15. ELECTRICAL CONNECTION · Connect the hood to the mains through a twopole switch having a contact gap of at least 3 mm. · Connect the control connector Cmd. · Connect the lights connector Lux. · Place the connectors in the junction box 24 and 12e close it using the 2 screws 12e (2, 9 x 9, 5) provided. · Fix the junction box to the hood body using the 2 screws 12c (2, 9 x 6, 5) provided. · For the recirculation version, fit the activated carbon odour filter. · Replace the grease filters. 12c 8b 12f 24 Lux Cmd GB 18 USE Control panel L S1 M V1 V2 S2 V3 L Light Switches the lighting system on and off. Flashes when the grease filters are saturated. [. . . ] · Replace the Support, fixing it in place with the two Screws removed as above. 21 GB Quest'apparecchio è conforme alla norma europea sulla bassa tensione C. E. E. 73/23 relativa alla sicurezza elettrica e alle norme europee: C. E. E. 89/336 relativa alla compatibilità elettromagnetica e C. E. E. This appliance conforms to European Low Voltage Directive 73/23/CEE governing electrical safety, European Directive 89/336/ CEE on Electromagnetic Compatibility and Directive 93/68/CEE regarding CE Marking. [. . . ]