User manual AEG-ELECTROLUX EFC9543X/A

[. . . ] USE · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. · Never use the hood for purposes other than for which it has ben designed. · Never leave high naked flames under the hood when it is in operation. · Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. [. . . ] · Lift up the frame, fit the frame slots onto the screws up to the slot end positions. · Tighten the two screws and fasten the other two screws provided with the hood. Before tightening the screws completely it is possible to adjust the frame by turning it. Make sure that the screws do not come out of their seats in the slotted holes. · The frame mountings must be secure to withstand the weight of the hood and any stresses caused by the occasional side thrust applied to the device. On completion, check that the base is stable, even if the frame is subjected to bending. · In all cases where the ceiling is not strong enough at the suspension point, the installer must provide strengthening using suitable plates and backing pieces anchored to the structurally sound parts. 1 1 2 2 Ducted version air exhaust system Connection When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. · To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. · Fix the pipe using the pipe clamps 25 provided. · Remove any activated charcoal filters. ø 150 ø 120 25 25 9 EN 7 7 Recirculation version air outlet · Fix the connection 15 to the frame using the 4 screws provided. · Fix the flange 10 to the lower opening of the connection 15. · Connect the hood air outlet to the flange in the lower part of the junction using a rigid or flexible ø 150 tube (by installer's choice). 10 15 Flue assembly - Mounting the hood body · Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. · Similarly, position the lower chimney section and fix the lower part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Before fixing the hood body to the frame: · Remove the grease filters from the hood body. · Remove any activated charcoal filters. · From below, use the 4 screws 12f (M6 x 10)provided to fix the hood body to the frame. 12c 12c 12f ELECTRICAL CONNECTION · Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. · Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. · Connect the control connector Cmd. · Connect the lights connector Lux. · Place the connectors in the junction box 24 and close it using the 2 screws 12e (2, 9 x 9, 5) provided. · Fix the junction box to the hood body using the 2 screws 12c (2, 9 x 6, 5) provided. · For the recirculation version, fit the activated carbon odour filter. [. . . ] · Remove the filters one by one pushing them towards the back side of the unit and simultaneously pulling downwards. · Any kind of bending of the filters has to be avoided when washing them. Before fitting them again into the hood make sure that they are completely dry. · When fitting the filters into the hood pay attention that they are mounted in correct position and that the handle faces outwards. EN 1 11 1 Odour filter (Recirculation Version) This filter cannot be washed or regenerated, and must be replaced when the F touch control starts to flash, or at least once every 4 months. [. . . ]