User manual AEG-ELECTROLUX EFC9673X

[. . . ] · Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. · The hood should not be used by children or persons not instructed in its correct use. · The appliance is not intended for use by young children or infirm persons without supervision. · Young children should be supervised to ensure that they do not play with the appliance. [. . . ] · For wooden beam ceilings, use 4 wood screws (not provided). · For wooden shelf, use 4 screws 12g with washers 22 and nuts 23, provided. EN 6 6 FIXING THE frame · Loosen the two screws fastening the lower chimney and remove this from the lower frame. · Loosen the two screws fastening the upper chimney and remove this from the upper frame. If you wish to adjust the height of the frame, proceed as follows: · Unfasten the eight metric screws joining the two columns, located at the sides of the frame. · Adjust the frame to the height required, then replace all the screws removed as above. · Insert the upper chimney stack from above, and leave it running free on the frame. · Lift up the frame, fit the frame slots onto the screws up to the slot end positions. · Tighten the two screws and fasten the other two screws provided with the hood. Before tightening the screws completely it is possible to adjust the frame by turning it. Make sure that the screws do not come out of their seats in the slotted holes. · The frame mountings must be secure to withstand the weight of the hood and any stresses caused by the occasional side thrust applied to the device. When pressed the motor is stopped, regardless of the speed it is set to. When pressed the motor is set to the first speed By a brief pressing the motor is set to the second speed. By pressing the touch control for approximately 2 seconds the Delay function is enabled, i. e delayed shutdown of the appliance ensuring a complete elimination of the residual odours. This function can be activated at OFF-position and at 1°, 2° and 3°speeds. It can be stopped in advance by pressing any of the touch controls (T) with the exception of T3. The Delay function works according to the following scheme: 1°speed / OFF = 20 minuets 2°speed = 15 minutes 3°speed = 5 minutes When pressed the motor is set to the third speed Indicator lights Touch control unlit Touch control lit Lights off Lights on L Touch control unlit Courtesy light on T1 T2 T3 Touch control lit Touch control unlit Motor on Motor off Touch control lit Touch control lit Flashing touch control Second speed on Delay function on T4 Touch control lit EN 9 9 Touch control Basic functions Indicator lights T5 F When pressed the motor is set to the intensive speed timed to 5 minutes. At the end of 5 minutes of intensive speed the hood starts again at the speed it was set Touch control lit to previously. In case the hood is set to the intensive speed directly from OFF-state it will then start from the first speed after 5 minutes of intensive speed. Touch control lit Metal grease filters satuWhen pressed for 4 seconds it resets the filter alarm ration alarm. Metal grease signal indicated by flashing of the touch control T1. This procedure can be carried out only when the The alarm starts up after motor is stopped. Flashing touch control 100 working hours. [. . . ] · Disconnect the mains power supply to the hood by removing the motor unit power supply cable connector, switching off the power supply at the Mains or turning the Main switch off. · Restore the connection, pressing and holding T2. · Release the touch control, touch controls L, T2 and F will light up normally. · Within 3 seconds press the touch control F until the key itself flashes to confirm as follows: · 2 flashes ­ Charcoal odour Filter saturation Alarm ENABLED · 1 flash - Charcoal odour Filter saturation Alarm DISABLED REPLACING THE CHARCOAL ODOUR FILTER Reset the alarm signal · Stop the motor. [. . . ]