User manual AEG-ELECTROLUX EFC9680X

[. . . ] The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. ⷠAny frying must be done with care in order to make sure that the oil does not overheat and burst into flames. ⷠAs regards the technical and safety measures to be adopted for fume discharging it is important to closely follow the relations provided by the competent authorities. ⷠThe hood must be regularly cleaned on both the inside and outside (AT LEAST ONCE A MONTH, it is in any event necessary to proceed in accordance with the maintenance instructions provided in this manual). [. . . ] The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood will revert to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will automatically turn off after 5 minutes. Self-T imer: times all the speed levels D2 (the point "D2 is flashing), and then D2" the cooker hood switches off: The self-timer is set as follows: 1st speed level 20 minutes 2nd speed level 15 minutes 3rd speed level 10 minutes P speed level 5 minutes The display shows the remaining operation time, at the end of the time an acoustic signal is heard. depressing the push-button again exits the function. Note: if you have a remote control b (special accessory) and the letter "b" appears on the display, you should replace the battery. ⷠShould the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds. After reconnecting the power supply wait 15 seconds and then check that the cooker hood is now operating correctly. This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Set in "OFF the hood. oFF" OFF Press buttons 1 and 3 simultaneously and hold them for 3 seconds. At first only the grease filter LED F will light up, but when the charcoal filter LED C lights up the saturation indicator will be enabled. To disable it: Press buttons 1 and 3 again simultaneously and hold them for 3 seconds, until the charcoal filter LED C goes out. Grease filter LED LED F will start to flash when it is time to clean the grease filter. Cleaning will be necessary after 40 working hours. Always comply with the maintenance instructions for the grease filter. Charcoal filter LED The charcoal filter LED C will start to flash when the charcoal filter needs to be replaced. This operation is necessary after approximately 160 working hours. Resetting the saturation indicator After cleaning or replacing the filters, press button 3 for 3 seconds until the grease filter LED F or the charcoal filter LED C stops flashing. Before performing any maintenance operation, isolate the hood from the off removing electrical supply by switching off at the connector and removing the connector fuse. Through Or if the appliance has been connected through a plug and socket, then the removed from plug must be removed from the socket. grease Metal grease filter · The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. [. . . ] If your appliance fails to work properly please carry out the following checks. The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood must be not less than 45cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this has to be taken into account. ⷠMake 4 holes as indicated, fit 4 rawl plugs into them and fix the bracket in place using 2 screws. [. . . ]