User manual AEG-ELECTROLUX EFCR0406X

[. . . ] 32 Ýçindekiler . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42 Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52 Contents Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52 Description of the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Charcoal filter LED (E) The charcoal filter LED E will start to flash when the charcoal filter needs to be replaced. This operation is necessary after approximately 160 working hours. Resetting the saturation indicator After cleaning or replacing the filters, press button A for 3 seconds until the Led D or the Led E stops flashing. The resetting of the saturation indicator MUST be donein stand-by, never disconnect the hood from the mains. Correct ventilation If the cooker hood is to work correctly there must be an under pressure in the kitchen. It is important to keep the kitchen windows closed and have a window in an adjacent room open. Control device for grease and charcoal filters This hood is fitted with a device that signals when it is necessary to clean the grease filter or the charcoal filter (in the case of recirculation version with charcoal filter). On delivery, the hood is not supplied with an charcoal filter, so the saturation indicator will be 55 Important If the hood is used together, for example, with an open-fire fireplace that takes air from the interior of the house, an eddy of air may take place that produces smoke in the room. This does not concern the carbon filter version. Maintenance and care Disconnect the hood from the power supply before starting any maintenance work by disconnecting the plug or removing the fuse. Deposits of fat on the filter and on the walls of the evacuation conduit are a fire danger if, for example, a cooker is left on (or in the case of other kinds of overheating). Cleaning the hood Clean the outside of the hood using a damp cloth and a neutral detergent. Never use products containing corrosive and abrasive agents or inflammable substances. Cleaning the grease filter Clean the filter every month or every two months, depending on how often the hood is used. The more the filter is cleaned, the greater will be the amount of fat it can capture. 3: · Press the metal clips on the anti-fat filter backwards and remove the filter downwards. · Replace the old bulb with a new one of the same type (3). · Close the lamp cover. 3 1 2 Fig. 5 Special Accessories Charcoal Filter Type 20 External motor (for external installation) 942 122 035 External motor (for internal installation) 942 122 036 What to do if If your appliance fails to work properly please carry out the following checks. Symptom The cooker hood will not start. . . The cooker hood is not working Solution Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected Check that: The fan speed is set high enough for the task. The kitchen is adequately vented to allow the entry of fresh air. If set up for recirculation, check that the charcoal filter is still effective. If set up for extraction, check that the ducting and outlets are not blocked. The safety cut-out device has been tripped. Turn off the hob and then wait for the device to reset. [. . . ] · Connect electrically (19) but do not connect the hood to the main panel of the house. Only models EFCR 943-941: It is also necessary to connect electrically to an external suction motor (see successive paragraph "Connection to an external motor". · Fix the flue (20a) to the support (20b). Let the lower section of the flue slide downward and insert it in the apposite housing on the upper part of the hood. [. . . ]