User manual AEG-ELECTROLUX EFCR143X

[. . . ] 38 Recirculating version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38 For both version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Mounting of carbon filter (for recirculating version) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 Using the hood . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] l The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. Please, keep to the provisions of official directives regarding the question of fumes discharge. l When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. l When installed, the hood must be not less than 65 cm. l The power cord should be drawn so that there is no risk of damage. 35 At use of cooker hood l No food must be cooked flambee underneath the hood. l The use of an unprotected flame is dangerous for the filters and could cause fires. l Never leave the deep-frying or frying pan over a cooker/hob. The oil contained in the pan may spontaneously ignite through overheating. l Observe the filter change or cleaning intervals. Failure to observe these intervals may cause the risk of fire through fat deposition. In order to install the cooker hood at the right height consider also that the height of the body of the hood is 290 and that a minimum distance from hobs must be in any case respected (see paragraph "Placement"). c b a a b b ! Fig. 5 Choose how to use the hood: Exhausting version l Fit a Ø 150 mm exhausting pipe or flex tube on the ceiling sufficiently long to reach the connection ring above the hood, once the hood will be fit on place. Recirculating version l Fit the deflector from one side of the slots of the upper section of the telescopic supporting structure (Fig. Slots used must be those perpendicular to the top fixing points for chimney unit. l Fix the deflector with bracket supplied and 4 screws 2, 9x6, 5 (Fig. Fix the deflector also on the other side of the structure with two other screws same shape. l From the bottom of the telescopic supporting structure fit the connection ring supplied (bajonett attachment- turn clockwise and fix definitively with one screw 2, 9x9, 5). 7) l Fit a section of pipe or flex tube Ø 150 mm sufficiently long to reach the connection ring of the hood once this hood will be fit on place (Fig. 7 38 For both versions: l Fix the supporting structure to the ceiling with 4 screws 5x45 and dowel (b - Fig. Sides with fixing points "c" for the external telescopic chimney correspond to the right and left sides (fig. The hood is supplied with installation fittings suitable for most kinds of ceilings, but in any case a qualified installation technician must be consulted in order to choose the best mounting solution. b The power plug must be disconnected from the mains during the mounting procedure. l Fix the upper and lower part of the utter chimney together temporarily with one screw "a" 2, 9x6, 5 (Fig. [. . . ] It should be changed when the Carbon filter saturation LED flashes. Ask the technical assistance service or manufacturing company for a new one. To remove the carbon filter, first remove the grease metal filters and then unscrew the two screws that holds the grease filter and pull the filter down (Fig. 14 Changing the lighting elements l With the help of a screwdriver remove the screw that secures the lens (Fig. [. . . ]