User manual AEG-ELECTROLUX EFCR948U

[. . . ] 47 Technical data. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48 40 Congratulations to your new Cooker Hood Thank you for your choice of an Electrolux product. We are convinced that you will have great use and pleasure from your new cooker hood. Before you use the cooker hood we recommend that you read through the whole user manual giving a direct description of the cooker hood and its functions. [. . . ] q Never leave the deep-frying or frying pan over a cooker/hob. The oil contained in the pan may spontaneously ignite through overheating. q Observe the filter change or cleaning intervals. Failure to observe these intervals may cause the risk of fire through fat deposition. If a fire starts; Switch of the cooker hood and the heating zone; Cover the fire , Never use water. At disposal q Help to avoid damages even when the cooker hood should be disposed. Disconnect the power plug and cut the power cord at hood inlet. Check with the authorities for information of how to proceed for disposal. Description of the appliance 1. Control panel containing work light 0 0I 2. Grease filters 2 pcs on model EFC 635 X 3 pcs on model EFC 935 X 2 3 4 1 Standard accessories included: Wall mounting template Screws No return valve Deflector Chimney support 5 5 Fig. 1 Function The hood may be used as follows: - Exhausting version - Recycling version Exhausting version The air is vented outdoors by a duct which must be connected to connecting ring with no return valve A (Fig. 2). A The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. Fig. q On the version EFC 935 X check that the two internal shutters S (Fig. 9) are open. H K h M K K K s Fig. 9 s Installing the duct for recycling into the room (Carbon filter version) Perform the same operations described in the preceding paragraph with regards to: q Fastening of top support H q Adjustment of duct If a no return valve in duct A (fig. Before mounting the duct, fasten, with the screws supplied, the air conveyor N inside the duct (fig. 10 Mounting of carbon filter q Remove the grease filter by pushing it towards the back of the hood and pulling it downwards. q The hood with the denomination EFC 935 X has two internal shutters S (fig. Before mounting the carbon filter they should be shut. 11 45 s s q Place the carbon filter in the front edge of the hood and fasten it with help of the two hooks at the back edge O (Fig. 12 Using the hood Using the controls To start the appliance, pull the control panel downwards for access to the light and motor switches. The hood has a microswitch so that once the motor speed has been selected and the light switched on, the hood can be started by simply pulling out the control panel. When the panel is closed, the hood switches off. [. . . ] 15 1 2 Carbon filter This filter dissolves cooking odours. It should be changed every 6-8 months in normal use. Ask the technical assistance service or manufacturing company for a new one. To remove the carbon filter, push the push-buttons O inwards and pull the filter downwards (Fig. [. . . ]