User manual AEG-ELECTROLUX EFG532X

[. . . ] · Since the rule for rooms with fuel burning appliances is "outlet hole of the same size as the ventilation hole", a hole of 500-600 cm2, which is to say a larger hole, could reduce the performance of the extractor hood. · If the hood is used in its filtering function, it will operate simply and safely in the above 3 conditions without the need for any of the aforementioned measures. · When the hood is used in its extractor function, the following rules must be followed to obtain optimal operation: -- short and straight outlet ducting -- keep bends in outlet ducting to a minimum -- never install the ducts with an acute angle, they must always follow a gentle curve. -- keep the duct as large as possible (preferably the same diameter as the outlet hole). [. . . ] Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 4 Description of the appliance Duct* · The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. · The hood is supplied as an extractor unit and can also be used with a recirculation version by fitting a charcoal filter. Cabinet Coupling ring Extractor version · In this version fumes are extracted to the outside via a duct connected to the coupling ring. · In order to obtain the best performance the ducting should have a diameter equal to the outlet hole. Fig. 1 * The duct is not supplied and must be purchased separately. Duct* Cabinet Recirculation Version · The air is filtered through charcoal filters and returned to the kitchen. · You will need original ELECTROLUX charcoal filters for the recirculation function. (Available from your local Service Centre) Charcoal filters Fig. 2 * The duct is not supplied and must be purchased separately. Control Panel · Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the hood's front panel: Light switch Motor switch Correct ventilation If the cooker hood is to work correctly there must be an under pressure in the kitchen. · This filter cannot be cleaned or reused. · As a general rule, the charcoal filter(s) should be changed once every four months. Remove the frame pushing the two side release keys "a". Fit each charcoal filter so to cover the plastic grid that protect the fan wheel, then turn clockwise the central handle of the charcoal filter. · To remove proceed in the reverse order. · Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. · The charcoal filter can be ordered from your local ELECTROLUX Service Centre. a b a a b Frame Fig. 6 Changing the light bulb · Disconnect the cooker hood from the main supply. · Remove the frame pushing the two side release keys "a". · Replace the old bulb with a new one of the same type. [. . . ] The hood can be installed above these heights but for optimum performance it should be installed at the distance quoted for the appropriate heat source. Fig. 7 Electrical connection Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. [. . . ]