User manual AEG-ELECTROLUX EFG6416S

[. . . ] The appliance is not intended for use by young children or infirm persons without supervision. Older children must be supervised if using the appliance. Young children should be supervised to ensure that they do not play with the appliance. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). [. . . ] Failure to observe these basic instructions will drastically reduce the performance and increase the noise levels of the extractor hood. The cooker hood is designed to from extract unpleasant odours from the kitchen, it will not extract steam. The hood is supplied as an extractor unit and can also be used with a recirculation mode by fitting a charcoal filter. extraction mode · In this mode fumes are extracted to the outside via a hose connected to the coupling ring ring. In order to obtain the best performance the hose should have a diameter equal to the outlet hole. The air is filtered through a charcoal charcoal filter and returned to the kitchen. You will need an original charcoal filter for the recirculation mode. Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. Correct ventilation: If the cooker Correct hood is to work correctly there must be an under pressure in the kitchen. Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). The charcoal filter should only be used if you want to use the hood in recirculation mode. To do this you will need an original charcoal filter (available from your local Service Force Centre). As a general rule, the charcoal filter(s) should be changed once every four months. Fitting Align the pins R on the cowl with the slots S, then turn the filter clockwise S until it locks in place. Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. The charcoal filter can be ordered from your local Service Force Centre. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Prior to touching the light bulbs ensure are ensure they are cooled down. [. . . ] When installing, an omnipolar disconnector with a distance of at least 3 mm between contacts must be provided. Fixed connection of the appliance must only be carried out by an authorised electrician. Warnings Safety warnings for the electrician Connect the hood to the mains supply via a double pole switch which has 3 mm minimum separation between the contacts. the switch must be accessible at all times. [. . . ]