User manual AEG-ELECTROLUX EFG70023S

[. . . ] · Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc. ). · If the extractor is used in conjunction with non-electrical appliances (e. g. gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. [. . . ] gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. · Never use the hood for purposes other than for which it has ben designed. · Never leave high naked flames under the hood when it is in operation. · Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. · Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. · The hood should not be used by children or persons not instructed in its correct use. · When opening the sliding carriage for the first time after installing the hood, pull it out briskly until it clicks. GB USE Control Panel L M V Light Motor Speed Switches the lighting system on and off Switches the extractor motor on and off Sets the operating speed of the extractor: 1. Low speed, used for a continuous and silent air change in the presence of light cooking vapour. 2. Medium speed, suitable for most operating conditions given the optimum treated air flow/noise level ratio. 3. Maximum speed, used for eliminating the highest cooking vapour emission, including long periods GB MAINTENANCE Grease filters CLEANING METAL SELF-SUPPORTING GREASE FILTERS · The filters must be cleaned every two months of operation, or more frequently with heavy usage, and can be washed in a dishwasher. · Remove the filters one at a time, after disconnecting the relative fastening elements. · Wash the filters, taking care not to bend them. · When refitting the filters, make sure that the handle is visible on the outside. Odour filters (Recirculation version) REPLACING ACTIVATED CHARCOAL FILTERS · These filters are not washable and cannot be regenerated, and must be replaced approximately every four months of operation, or more frequently with heavy usage. · Remove the saturated activated carbon filters by releasing the fixing hooks. · Fit the new filters by hooking them into their seating · Replace the grease filters. Lighting LIGHT REPLACEMENT 40 W incandescent light · Remove the metal grease filters, or open the filter retaining grill · Unscrews the bulbs and replace them with new ones having the same characteristics. [. . . ] · When refitting the filters, make sure that the handle is visible on the outside. Odour filters (Recirculation version) REPLACING ACTIVATED CHARCOAL FILTERS · These filters are not washable and cannot be regenerated, and must be replaced approximately every four months of operation, or more frequently with heavy usage. · Remove the saturated activated carbon filters by releasing the fixing hooks. · Fit the new filters by hooking them into their seating · Replace the grease filters. Lighting LIGHT REPLACEMENT 40 W incandescent light · Remove the metal grease filters, or open the filter retaining grill · Unscrews the bulbs and replace them with new ones having the same characteristics. [. . . ]