User manual AEG-ELECTROLUX EFG714G

[. . . ] When installing the hood, make sure you respect the following minimum distance from the top edge of the cooking hob/ring surfaces: electric cookers 600 mm gas cookers 700 mm The hood can be installed above these heights but for optimum performance it should be installed at the distance quoted for the appropriate heat source. The national Standard on fuel-burning systems specifies a maximum depression of 0. 04 mbar in such rooms. The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed. [. . . ] It is important to keep the kitchen windows closed and have a window in an adjacent room open. Fig. 3 5 Maintenance and Care The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products. Never insert pointed objects in the motors protective grid. Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. Only ever clean the control panel and filter grille using a damp cloth and delicate detergents. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). Grease filter The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal recycling function. Handle Metal grease filter - only for model EFG 540 The metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Fit each charcoal filter so to cover the plastic grid that protect the fan wheel, then turn clockwise the central handle of the charcoal filter. To remove proceed in the reverse order. Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. The charcoal filter can be ordered from your local ELECTROLUX Service Force Centre. a b a a b Frame Fig. 7 Charcoal filters (EFG 540 : 2 pieces - EFG 535 : 1piece) Fig. 8 Changing the light bulb Disconnect the cooker hood from the main supply. Remove the frame pushing the two side release keys "a". Replace the old bulb with a new one of the same type. If the light does not come on, make sure the bulb has been inserted correctly before contacting your local Service Force Centre. 7 Something Not Working If your appliance fails to work properly please carry out the following checks. The cooker hood is not working Solution Check that: The hood is connected to the electricity supply. [. . . ] They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances. France Germany Italy Sweden UK Senlis Nürnberg Pordenone Stockholm Luton +33 (0)3 44 62 20 13 +49 (0)800 234 7378 +39 (0) 800 117511 +46 (0)20 78 77 50 +44 (0) 8705 950 950 10 Technical Specifications Model Dimensions Height (cm) Width (cm) Depth (cm) EFG 540 13, 9 52, 4 28, 9 2 x 40 W 2 320 W 220-240 V EFG 535 13, 9 52, 4 28, 9 2 x 40 W 1 200 W 220-240 V Lighting Grease filter Power absorption Electrical connection: Subject to change without notice. Installation Unpacking Check that the cooker hood has no damages. Transportation damages should immediately be reported to the company responsible for the transportation. Damages, faults and eventually missing details should immediately be reported to the retailer. [. . . ]