User manual AEG-ELECTROLUX EFG750X/A

[. . . ] · For Class 1a appliances, check that the domestic power supply guarantees adequate earthing. Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. The route of the flue must be as short as possible. [. . . ] · The hood should not be used by children or persons not instructed in its correct use. MAINTENANCE · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. · Clean and/or replace the Filters after the specified time period. · Clean the hood using a damp cloth and a neutral liquid detergent. 650mm. min. GB CHARACTERISTICS Dimensions ø150 L 284 Hood Type L1 52 522 70 702 Components 9 Ref. 1 9 Q. ty Product Components 1 Hood Body, complete with: Controls, Light, Filters 1 Reducer Flange ø 150-120 mm Q. ty Documentation 1 Instruction Manual 1 12f GB 260 INSTALLATION Drilling the Support surface and Fitting the Hood Make a rectangular opening on the base of the hanging unit, leaving a minimum of 13 mm from the outer edges. Hood Type L1 52 497 70 677 259 13 L1 SNAP-ON FITTING For hoods with snap-on side supports only, set up for a support panel thickness of between 15 mm and 30 mm. · Insert the hood until the side supports snap into place. · Lock in position by tightening the screws Vf from underneath the hood. SCREW FITTING For hoods without snap-on side supports only. · Fix the hood to the hanging unit using the screws 12f (3. 5x16 self-threading) provided. 12f GB Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 120 or 150 mm, the choice of which is left to the installer. · To install a ø 120 mm air exhaust connection insert the reducer flange 9 on the hood body outlet. · Fix the pipe in position using sufficient pipe clamps (not supplied). · Remove any activated charcoal filters. 9 ø 150 ø 120 9 RECIRCULATION VERSION AIR OUTLET · Cut a hole ø 120 mm in the wall unit over the hood. · Insert the reducer flange 9 on the hood body outlet. · Connect the hood body outlet to the top part of the wall unit using a rigid or flexible pipe ø 120 mm, to be selected by the installer. · Fix the pipe in position using sufficient pipe clamps (not supplied). · Ensure that the activated charcoal filters have been inserted. 120 125 9 9 ELECTRICAL CONNECTION · Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. · When opening the sliding carriage for the first time after installing the hood, pull it out briskly until it clicks. GB USE Control Panel L M V Light Motor Speed Switches the lighting system on and off Switches the extractor motor on and off Sets the operating speed of the extractor: 1. Low speed, used for a continuous and silent air change in the presence of light cooking vapour. [. . . ] · Replace the metal grease filters, or close the filter retaining grill. GB Dir. 89/336/CEE 73/23/CEE 93/68/CEE The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ]