User manual AEG-ELECTROLUX EFI60011S

[. . . ] User Manual EFI 60011 EFI 60012 EFI 60013 UK Contents UK Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 For the installer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 For the user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Description of the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Replacement filters are available from your local Service Force Centre. 6 Remove the grill or the metal grease filter. Place the charcoal filter to cover the grill that protects the extraction motor so that the slots on the filter correspond to the pins on the sides of the motor protection grill. Turn the filter clockwise in order to lock the filter into position. Remount the grid or the metal grease filter. · To remove proceed in the reverse order. · Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. · The charcoal filter can be ordered from your local Service Force Centre. Fig. 6 - EFI 60011 - EFI 60012 EFI 60013 = 2 charcoal filters Changing the light bulbs · Disconnect the cooker hood from the mains supply. · Remove the grill or the metal grease filter. · Replace the old bulb with a new one of the same type. · Remount the grid or the metal grease filter. · If the light does not come on, make sure the bulb has been inserted in correctly before contacting your local Service Force Centre. 8 Special accessories Charcoal filter type 29 What to do if If your appliance fails to work properly please carry out the following checks. Symptom The cooker hood will not start. . . Solution Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected Check that: The fan speed is set high enough for the task. The kitchen is adequately vented to allow the entry of fresh air. If set up for recirculation, check that the charcoal filter is still effective. If set up for extraction, check that the ducting and outlets are not blocked. The safety cut-out device has been tripped. Turn off the hob and then wait for the device to reset. [. . . ] They will serve to adjust the position of the hood at the moment of installation. 9 Note: the position of the brackets can be adjusted during installation, suitably loosening and retightening the screws that fix them to the hood. Rear view Ø 5x18 Ø 5x10 Fig. 9 Fixing a furniture door to the visor · Remove the extraction grill or the metal grease filter. · Remove the visor (freeing the locking releases Fig. [. . . ]