User manual AEG-ELECTROLUX EFT500

[. . . ] We are convinced that you will have great use and pleasure from your new cooker hood. Before you use the cooker hood we recommend that you read through the whole user manual giving a direct description of the cooker hood and its functions. To avoid the risks, that are always present when you use a product driven by electricity, it is important that the cooker hood is installed correctly and that you read the safety instructions carefully to avoid misuse and hazard. [. . . ] Connect the hood to the smoke exhaust hose by using the connecting ring G with no return valve. Insert plug H in the unused exhaust hole (bayonet coupling). In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. The hood cannot be connected to flues of other appliances that run on energysources other than electricity. G D E H Fig. 2 Recycling The air is filtered through a carbon filter and recirculated into the room through the front grid (fig. This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. Fig. 3 20 Special accessories Active carbon filter When the hood is used in recirculation mode an active carbon filter should be used. Order by the retailer PNC 955 101 117 Flex tube kit When the hood is to be connected to an evacuation channel use the flex tube kit containing one evacuation flex tube, one roof connecting duct and two tube clamps. PNC 391 414 201 Installation Unpacking Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller. Take care of the packing material so that small children cannot play with it. Min 65 cm Min 75 cm Placement The hood is to be mounted on the wall or under a wall cupboard. When installed, the hood must be not less than 65 cm. 4 Electrical connection The hood has a power cord with moulded plug with earth connection to be connected to a wall outlet of 230 V. The power cord length is 1, 2 m. I L I I Mounting of hood on wall q Fix the drilling template to the wall (Fig. q Make 3 Ø 8 mm holes in the wall. 2 at points I, 1 as desired at points L. q Insert the three Ø 8 mm expansion plugs into the wall. q Insert 2 5x45 screws at points I but do not tighten them completely. [. . . ] q Release the clips B that stop the filter (Fig. Grid must be cleaned as well as the grease filter. B Fig. 12 B Carbon filter This filter dissolves cooking odours. [. . . ]