User manual AEG-ELECTROLUX EFT520B/CH

[. . . ] 31 Carbon filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31 Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 Attention . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 Changing the lighting elements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 If the hood does not function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Disconnect the power plug and cut the power cord at hood inlet. Check with the authorities for information of how to proceed for disposal. 27 Description of the appliance 1. Suction grid with grease filter Work light Light switch Motor speed switch Bracket 3 4 Standard accessories included: q Template for mounting on wall and under cupboard q Screws: q Duct with no return valve q Cover for unused outlet hole q Bracket 1 5 Fig. 1 2 G Function The hood may be used as follows: - For air exhausting - For air recycling H Exhausting The appliance has two exhaust outlets; D and E (Fig. To use the back hole E, remove air switch F from the top hole. Connect the hood to the smoke exhaust hose by using the connecting ring G with no return valve (bayonet coupling). Insert plug H in the unused exhaust hole (bayonet coupling). In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. Please keep to the provisions of official directives regarding the question of fumes discharge. D E F D E Fig. 2 Recycling The air is filtered through a carbon filter and recirculated into the room through the front grid (fig. This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. 3 Special accessories Active carbon filter When the hood is used in recirculation mode an active carbon filter should be used. Order by the retailer PNC 942 120 180 Installation Unpacking Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller. Take care of the packing material so that small children cannot play with it. Min 60 cm Min 70 cm Placement The hood is to be mounted on the wall or under a wall cupboard. When installed, the hood must be not less than 60 cm. 4 Before mounting the hood Place the metal stops on the rear square holes Q. [. . . ] 11 Maintenance Before performing any maintenance operation, disconnect the hood from the electricity. Grease filter This serves to hold the grease particles in suspension. The metal filter should be washed every month with warm soapy water or, if possible, in the dishwasher (60°C). Remove the filter: q Open the latch and rotate the grid downwards (Fig. [. . . ]