User manual AEG-ELECTROLUX EFT60003X

[. . . ] The manufacturer disclaims all liability for any damage or injury caused as a result of not following the instructions for installation contained in the following text. SAFETY WARNINGS plant of your house is correctly earthed. 1. 5- Appliance in class II are provided with a double insulation; therefore do not connect then through earthed plugs but through simple bipolar plugs. 1. 6- When installed, the hood must be positioned at least 65cm above the hotplate. [. . . ] b-If the hood is not provided with a paper fixing template, drill two Ø 8mm holes (see draw. ), insert the plugs and screws, proceeding as directed under paragraph a. c-For wall mounting using wallbrackets (optional), follow the instructions of the fixing template. d-Pay attention to the safety regulation of point 1. 6. 2. 4 - Choice of operating mode a - Evacuation mode To check that the hood is set up for evacuation, open the grille panel and make sure that the conversion lever or the change-over knob on the centrifugal unit is in the DUCTING position. For ducting to the outside, the hood is supplied with a rear and top outlet. A flange spigot of 100 mm diameter (120 mm in certain models) is usually fitted on the top outlet and a blanking plug on the rear outlet. If you choose to duct the hood from the rear of the casing, you should invert the position of the flange and of the blanking plug. Pay attention to the safety regulation 1. 1. b - Internal recirculation mode To check that the hood is set up for recycling, open the grille panel and make sure that the conversion lever or the change-over knob on the centrifugal unit is in the RECYCLING position. To fit the charcoal filter, support the filter with one hand and turn the thumb screw through the centre of the charcoal filter. If the filter is of the interlocking type, turn the filter clockwise. The hood can remain connected to the outside. 2. 5 - Electrical connection and working test 1-The safety measures 1. 2, 1. 3, 1. 4 and 1. 5 of paragraph 1 are to be strictly observed. 2-Once the electrical connection has been completed, check that the worktop illumination, motor and speeds work properly. EN 8 electrolux Installation USE 3 - OPERATION EN 3. 1- Controls are located on the right hand side of the front to operate worktop illumination and select the most suitable working speed for your cooking. To increase the area of extraction, the glass visor should be pulled open. The top speed should be used when frying or cooking foods with strong odours, while a lower speed can be used for normal cooking. [. . . ] · When refitting the filters, make sure that the handle is visible on the outside. 4. 3 - Charcoal filter The charcoal filter is a chemical filter to be used only when the hood is in the recycling position. To replace the charcoal filter, open the grille and remove the thumb screw through the centre of the charcoal filter. [. . . ]