User manual AEG-ELECTROLUX EFT625

[. . . ] We are convinced that you will have great use and pleasure from your new cooker hood. Before you use the cooker hood we recommend that you read through the whole user manual giving a direct description of the cooker hood and its functions. To avoid the risks, that are always present when you use a product driven by electricity, it is important that the cooker hood is installed correctly and that you read the safety instructions carefully to avoid misuse and hazard. Save the instruction manual and keep it available at use of the cooker hood Safety instructions At installation and service l The cooker hood is made for normal households with normal cooking. [. . . ] Suction grid with grease filter 0 I 1 0 I 2 3 2 EFT 625 - 925 Standard accessories included: l Template for mounting on wall and under cupboard l Screws: l Duct with no return valve l Plug for unused outlet hole 4 3 Fig. 1 Function The hood may be used as follows: - For air exhausting - For air recycling Attention!The Cooker hood is ready to be used for air recycling (carbon filter already mounted in place). G H Exhausting The appliance has two exhaust outlets; D and E (Fig. To use the back hole E, remove air switch F from the top hole. Connect the hood to the smoke exhaust hose by using the connecting ring G with no return valve (bayonet coupling). Insert plug H in the unused exhaust hole (bayonet coupling). In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. D E F D E Fig. 2 Recycling The air is filtered through a carbon filter and recirculated into the room through the front grid (fig. This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. 3 Special accessories Active carbon filter When the hood is used in recirculation mode an active carbon filter should be used. Order by the retailer PNC 942 120 180 Installation Unpacking Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller. Take care of the packing material so that small children cannot play with it. Min 60 cm Min 70 cm Placement The hood is to be mounted on the wall or under a wall cupboard. When installed, the hood must be not less than 60 cm. 4 H I H I Electrical connection The hood has a power cord with moulded plug with earth connection to be connected to a wall outlet of 230 V. The power cord length is 1 m. H Mounting of hood on wall l Fix the drilling template to the wall (Fig. l Make 3 Ø 8 mm holes in the wall. 2 at points H, 1 as desired at points I. l Insert the three Ø 8 mm expansion plugs into the wall. l Insert 2 5x45 screws at points H but do not tighten them completely. l Fit the hood into holes H, tighten the 2 screws. CLOSED I H I I H Fig. [. . . ] In stead a window in an adjacent room should be open. Important to know If the hood is run at the same time as a burner or fireplace that depend on ambient air (for example gas, Diesel, coal or wood heaters, water heaters, etc. ) be careful, because the hood, when it exhausts the air, removes the ambient air required by the burner or fireplace for combustion. Not valid if the cooker hood is used in recirculation mode. Fig. 11 Maintenance Before performing any maintenance operation, disconnect the hood from the electricity. CLOSED A OPEN 2 Grease filter This serves to hold the grease particles in suspension. Model EFT 625 is supplied with two grease filters, model EFT 925 is supplied with one grease filter. [. . . ]