User manual AEG-ELECTROLUX EFT630K/GB

[. . . ] Before installing or using this appliance please read this instruction book carefully paying particular attention to the safety warnings on the following page. If you have any queries regarding this appliance please contact Customer Care for advice. Please keep this instruction book for future reference and pass it on to any future owner of the appliance. When used as an extractor unit, the hood must be fitted with a 125mm diameter hose. [. . . ] The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. EFT 635-535-531-9460-6460 (1 or 2 filters) The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal recycling function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Removing the metal grease filter First pull the latches backwards (a), then extract the grille outwards (b). Hand washing Soak grease filters for about one hour in hot water with a little washing-up liquid added, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external evacuation or internal recycling function. The paper grease filter is very thin (approx. 1 mm) and positioned on the inside of its related support grille. The filter should be changed once a month. The grille should be cleaned with luke warm water and non-abrasive detergent when you change the filter. The grease filter can be ordered from your local Service Force Centre. opening the grille Open the latch and swing the grille downwards. To remove the grille, pull it forwards from the right and release it. Removing the filter Open the grille and remove the stops to take out the filter. The charcoal filter should only be used if you want to use the hood in the recirculation function. To do this you will need an original charcoal filter (available from your local Service Force Centre). [. . . ] When installed, the hood must be not less than 50 cm. The hood can be installed above these heights but for optimum performance it should be installed at the distance quoted for the appropriate heat source. Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. [. . . ]