User manual AEG-ELECTROLUX EFT630W

[. . . ] Environmental information. Installation and assistance Every eventual electrical connection must be carried out by a specialised electrician and the installation of the hood must be carried out by a qualified technician. The installation of the hood by non-qualified personnel can lead to malfunctioning of the hood and cause damage to people and/or objects. Installation must be carried out in conformity with the Boverket regulations. The hood must be installed at least 400 mm above the cooking top or electric plates, or at least 650 mm above gas rings or gas tubes. [. . . ] Best results are obtained using a low speed in normal conditions and a high speed when odours are more concentrated. Intensive speed key. Intensive speed lasts for 5 minutes. The time may vary slightly and cannot be modified. Press the intensive speed key again if you want to interrupt the intensive speed before the established time limit. If the hood is functioning when intensive speed is started, it will return to the previously set speed once the time limit has passed, or intensive speed has been interrupted. If the hood is off when intensive speed is started, it will automatically witch itself off at the time limit. It is, for example, opportune to use intensive speed for the evacuation of odours after having finished cooking. Important If the hood is used together with an open fireplace that takes air from inside the house, a draught might occur that could bring fumes into the room. This does not concern the active carbon filter version. Do not use the hood at an excessive speed. The lower speeds are sufficient for normal cooking. The higher speeds must only be used if food has been burnt or there is a particular concentration of fumes. The control panel The speed control is on the front of the hood. We advise switching the hood on a few minutes before starting to cook so as to obtain the vacuum in the kitchen and to leave it working at the end of cooking for another 15 minutes until all fumes and odours have disappeared. Maintenance and cleaning Disconnect the hood from the power before any maintenance work, removing the plug or the fuse. Clean all the plastic and metal parts by hand with hot water and a detergent for crockery. Clean the acoustic insulation delicately with a wet cloth. The montage must be carried out in the reverse order. Do not screw the three screws of the front door up too tightly. 4 B C E 2 1 A Changing the fluorescent tube. The hood must be disconnected from the power when changing the lamps. Remove the glass of the lamp by pressing the two fastenings forward (see figure). Change the broken fluorescent lamp with a new and equivalent tube. To avoid damaging the fluorescent tube during dismantling, protect the end of the fluorescent tube with a finger and pull it delicately. A 38 When the hood does not function Before contacting the assistance service Read the use instructions and check the following points to verify whether it is possible to deal with the fault yourself. Is the fuse in the electricity plant intact? Is the evacuation tube corrected mounted? Is the fluorescent tube whole and correctly inserted? Complaints Swedish law on consumer protection is valid in the case of sale to a client in Sweden. Remember to keep the receipt for eventual complaints. Client service Assistance and spare parts If the assistance service is called to solve one of the above-mentioned problems, the client risks having to pay the cost. [. . . ] The hood has a supply cable and a plug provided with grounding and a voltage of 230V. Mounting the hood in the lower part of the wall unit 1. Make a hole in the base of the upper wall unit. Use the template printed on the packaging. Hold the hood in the correct position and tighten the screws (A) with the spacers (B) inserted (see figure). [. . . ]