User manual AEG-ELECTROLUX EFT9460K

[. . . ] · The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood must be not less than 40cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. · Before any cleaning or maintenance operation, disconnect the hood from the mains by removing the plug or disconnecting the home mains switch. · The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or know-how, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. [. . . ] · You will need an original charcoal filter for the recirculation mode. (See Special Accessories). Extraction mode · In this mode fumes are extracted to the outside via a hose connected to the coupling ring ring. · In order to obtain the best performance the hose should have a diameter equal to the outlet hole. Recirculation mode · The air is filtered through a charcoal filter and returned to the kitchen. · You will need an original charcoal filter for the recirculation mode. (See Special Accessories). 8 electrolux control panel Control Panel GB · Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. · The control panel is under the cooker hood. Lighting switch, on and off. electrolux maintenance and care 9 Maintenance and Care GB · Warning!Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Replace in reverse order. GB C B A Warning · Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. · The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. 12 electrolux maintenance and care Changing the light bulb(s) GB · Disconnect the cooker hood from supply. · Prior to touching the light bulbs ensure they are cooled down. · Remove the lampglass by pushing the two snaps forwards (see picture). · Replace the damaged part with one of equal rating. To remove the light without damaging it, place a finger on the end of the light and pull gently. · If the light does not come on, make sure the bulb has been inserted in correctly before contacting your local Service Force Centre. electrolux maintenance and care 13 Cleaning the hood GB · Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. · Never use corrosive, abrasive or flammable cleaning products or products containing bleach. · Never insert pointed objects in the motor's protective grid. · Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid. · Clean all the plastic parts with a soft cloth soaked in warm water and neutral soap. · It is extremely important to clean the unit and change the filters at the recommended intervals. [. . . ] If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area apply a bi-polar switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with installation instructions. Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled. Mains supply replacement must be undertaken by your local Service Force Centre. 18 electrolux installation GB Do not connect the appliance to the mains until the installation is fully complete. Mounting of cooker hood in a cupboard, Alt. 1 · Cut an opening and drill 4 holes in the underside of the cupboard. Use the template printed on the packaging. [. . . ]