User manual AEG-ELECTROLUX EGE6182NOK

[. . . ] You've chosen a product that brings with it decades of professional experience and innovation. ingenious and stylish , it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you'll get great results every time. Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. [. . . ] Turn the control knob counterclockwise to the maximum position ( ) and push it down. Keep the control knob pushed for approximately 5 seconds; this will let thermocouple to warm up. If after some tries the burner does not light, check if the crown and its cap are in correct positions. To put the flame out, turn the knob to the symbol . Always turn the flame down or switch it off before removing the pans off the burner. To switch on and increase the heat setting turn the knob clockwise. To decrease the heat setting turn the knob counter-clockwise. Power indicator is activated when electric cooking zone is turned on, and will stay on until electric cooking zone is switched off. When a cooking zone operates, it hums for a short time. This is typical of all ceramic glass cooking zones and does not show that the appliance operates incorrectly. Put on all cooking zones a pan filled with some water. Set the maximum position and operate the appliance for approximately 10 minutes until water inside the pans boils. after that , operate the appliance at minimum position for 20 minutes. During this period, an odour and smoke can occur. After this operation, clean the appliance with a soft cloth soaked in warm water. Put cookware on a cooking zone before you start it. â· Stop the electrical cooking zones before the end of the cooking time to use residual heat. â· The bottom of pans and electrical cooking zones must have the same dimensions. â· The bottom of the cookware must be as thick and flat as possible. â· When the liquid starts to boil, turn down the flame to barely simmer the liquid. Use cookware with diameters applicable to the size of burners. Make sure pot handles do not protrude over the front edge of the cooktop and that pots are centrally positioned on the rings in order to achieve maximum stability and to obtain lower gas consumption. [. . . ] â· If you change from natural gas G20 13 mbar1) to natural gas G20 20 mbar to tighten the by-pass screw about 1/4 of a turn. Make sure the flame does not go out when you quickly turn the knob from the maximum position to the minimum position. Blue neutral cable must be connected to the terminal block label with "N". The brown (or black) phase cable (fitted in the terminal block contact marked with "L") must always be connected to the live phase. [. . . ]