User manual AEG-ELECTROLUX EGG9363

[. . . ] EGG 9363 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . EN HOB USER MANUAL 2 www. electrolux. com CONTENTS 1. 14 WE'RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. [. . . ] PRODUCT DESCRIPTION 2. 1 Cooking surface layout 1 2 5 3 4 1 Auxiliary burner 2 Semi-rapid burner 3 Triple Crown burner 4 Control knobs 5 Rapid burner 2. 2 Control knobs Symbol Description no gas supply / off position ignition position / maximum gas supply Symbol Description minimum gas supply 3. Refer to "Safety information" chapter. 3. 1 Ignition of the burner WARNING!Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame 6 www. electrolux. com Always light the burner before you put cookware. To light the burner: Turn the control knob counterclockwise to the maximum position ( ) and push it down. Keep the control knob pushed for approximately 5 seconds; this will let thermocouple to warm up. If not, the gas supply will be interrupted. Adjust the flame after it is regular. 1. WARNING!Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute. In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clockwise to maximum gas release position. If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute. The spark generator can start automatically when you switch on the mains, after installation or a power cut. It is normal. If after some tries the burner does not light, check if the crown and its cap are in correct positions. A B C D 3. 2 Turning the burner off To put the flame out, turn the knob to the symbol . A B WARNING!Always turn the flame down or switch it off before you remove the pans from the burner. C D A) B) C) D) Burner cap Burner crown Ignition candle Thermocouple 4. Refer to "Safety information" chapter. 4. 1 Energy savings · If possible, always put the lids on the pans. ENGLISH 7 · When the liquid starts to boil, turn down the flame to barely simmer the liquid. Use cookware with diameters applicable to the size of burners. Burner Triple Crown Rapid Semi-rapid Auxiliary Diameters of cookware 180 - 260 mm 160 - 260 mm 120 - 220 mm 80 - 180 mm WARNING!Make sure pot handles do not protrude over the front edge of the cooktop and that pots are centrally positioned on the rings in order to achieve maximum stability and to obtain lower gas consumption. Do not place unstable or deformed pots on the rings to prevent from spill and injury. Information on acrylamides Important!According to the newest scientific knowledge, if you brown food (specially the one which contains starch), acrylamides can pose a health risk. Thus, we recommend that you cook at the lowest temperatures and do not brown food too much. WARNING!Do not put the same pan on two burners. 5. [. . . ] If it is necessary to change the fuse, use a 3 amp ASTA-approved (BS 1362) fuse. 7. 4 Adjustment of minimum level To adjust the minimum level of the burners: 1. With a thin screwdriver, adjust the bypass screw position. A A) The by-pass screw · If you change from natural gas G20 20 mbar to liquid gas, fully tighten the bypass screw in. · If you change from liquid gas to natural gas G20 20 mbar, undo the by-pass screw approximately 1/4 of a turn (1/2 of a turn for Triple Crown burner). Make sure the flame does not go out when you quickly turn the knob from the maximum position to the minimum position. 7. 5 Electrical connection · Make sure that there is access to the mains plug after the installation. 12 www. electrolux. com A B The current regulations let only a qualified electrician or a competent person to replace the mains cable. [. . . ]