User manual AEG-ELECTROLUX EHE60020X

[. . . ] In other words, a kitchen unit taller than the hob unit may be positioned on one side of it, but not on both sides. On at least one side, there must be no unit taller than the hob unit itself. Cut the tabletop according to the prescribed dimensions or template (cut exactly in the lines). [. . . ] - The cutting measures are shown on fig. Check that the gasket is placed correctly and in continuity. Place the hob in the cutout, properly centered. Use a screwdriver, possibly for crossrecessed screws, for tightening the fastening screws, starting at the middle and proceding with the screw diagonally opposite, tightening evenly until the edge of the hob is held firmly against the tabletop. 1 40 mm 40 28 mm 28 17 GB Attention! Do not tighten more than necessary!Do not use power tools without an adjustable slipping clutch!The installation must ensure that live parts cannot be touched incidentally. Kitchen utensils get hot on the hob, so exert care. Do not keep temperature sensitive or inflammable materiale in drawers immediately below the hob. -This applies for example to detergents and aerosols. Be careful with other kitchen tools plugged in close to the hob. Their flex should never touch the hot plates. Important Notice for Enamelled Hobs Enamelled surfaces are hard as glass and require special care. Hard and sharp objects may damage enamel. Enamelled surfaces may splinter if heavy objects are dropped on them. [. . . ] Hard and sharp objects may damage enamel. Enamelled surfaces may splinter if heavy objects are dropped on them. Fruit juice spots should be washed off before they leave permanent stains. [. . . ]