User manual AEG-ELECTROLUX EHE64X

[. . . ] Electric Hobs INSTRUCTION BOOKLET INSTRUCTION Mod. EHE 64 35678-3202 AU Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred, always ensure that the book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings. These warnings are provided in the interest of safety. [. . . ] Alternatively, wipe the plates with a drop of olive oil on a kitchen towel to avoid rust. It is important to note that the plate will smoke a little and produce a slightly unpleasant odour when next used. Failure to clean and condition hotplates may lead to rust and corrosion forming on the surface. Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. SOLUTION Check that the unit is plugged in and the electrical supply is switched on Check that the RCCB has not tripped (if fitted) Check the mains fuse has not blown Check the correct control knob has been turned. The plate is not giving satisfactory results Check the plate is clean and dry Check the cooking pan is the correct size for the plate. Check the cooking pan has a flat bottom Check the setting is correct for the type of cooking. 5 Instructions for the Installer Engineers technical data Overall dimensions Width: Depth: 580 mm. 500 mm. Important safety requirements This hob must be installed by qualified personnel, according to the manufacturer's instructions and to the relevant Australian Standards. Cut out dimensions Width: Depth: 550 mm. 470 mm. Location This hob has been registered as a "Class X" appliance according to Fire Risk Regulations. Minimum distances detailed below must be observed. The hob may be located in a kitchen, a kitchen/diner or bed sitting room, but not in a bathroom or shower room. Before making the cut out in the worktop ensure that there is a minimum distance of 55 mm. between the rear edge of the hob and the wall. must be left between the side edges of the hob and any adjacent cabinets or walls. The minimum distance combustible material can be fitted above the hob in line with the edges of the hob is 400 mm. must be allowed from the edges of the hob. The minimum distance combustible material can be fitted directly above the hob is 700 mm. Supply connections Electric: 230-240V 50Hz AC electrical supply Heating elements Ratings Normal back left Hotplate Ø 145 mm Normal back right Hotplate Ø 180 mm Rapid front right Hotplate Ø 145 mm Rapid front left Hotplate Ø 180 mm Total rating 1045 W 1570 W 1570 W 2090 W 6. 7 kW INSTALLATION GUIDANCE INSTRUCTIONS CLEARANCES REQUIRED WHEN FITTING THE HOB WITHOUT A COOKER HOOD ABOVE INSTALLATION GUIDANCE INSTRUCTIONS CLEARANCES REQUIRED WHEN FITTING THE HOB WITH A COOKER HOOD ABOVE 600 mm 700 mm 650 mm 700 mm 400 mm 50 m 55 m mm 400 mm 100 400 mm 55 mm 50 m m 400 mm 100 mm 50 m m mm 50 m m FO 0812 FO 0813 6 Installation The hob must be installed according to the instructions supplied. The hob must be installed by qualified personnel to the relevant Australian Standards. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown. CAUTION: The surface temperature exceeds 95 deg C. To avoid a hazard, underbench access must be restricted. Cut Out Size The dimensions of the cut-out are given in the diagram. Rectangular cut-out size for hob 55 m in. 117 20 R 60 470 When the hob is first installed Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. 30 550 Building In Building over a cupboard or drawer If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. It is also recommended to carry out the electrical connection to the hob as shown in diagrams 1 and 2. 1 ON/OFF SWITCH FLEX OUTLET FO 0763 2 ON/OFF SWITCH FLEX OUTLET FO 0764 7 Building over a kitchen unit with door Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be hot when in operation. [. . . ] 16 Use of this appliance for commercial purposes is covered by this warranty for a period of 3 months from the date of purchase. FOR SERVICE IN AUSTRALIA PLEASE CALL 13 13 49 FOR SPARE PARTS IN AUSTRALIA PLEASE CALL 13 13 50 10 ELECTROLUX APPLIANCE WARRANTY ­ NEW ZEALAND This appliance is warranted by Electrolux Home Products (NZ) Ltd ("the Company") from the date of purchase. The following terms and conditions apply: 1 The Company or its Authorised Service Centre will pay the cost of repairing or replacing all parts of the appliance which the Company or its Authorised Service Centre find defective for a period of 24 months following the date of purchase (the "Warranty Period"). 2 During the Warranty Period the Company or its Authorised Service Centre, will pay the cost of repairing or replacing all parts, which they find are defective. [. . . ]