User manual AEG-ELECTROLUX EHG 30230

[. . . ] Subject to change without notice These instructions are only valid in the countries whose symbols appear on this booklet's cover. For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know the operation and safety features of the appliance. [. . . ] ⭠Flat the external gas pipes if there are fitted. ­ Speak to your local authorised facilities for disposal of your appliance. The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. Gas Connection It is necessary that the connection to the gas mains are carried out by means of an AGB tap. Choose fixed connections or use a flexible pipe in AGB (stainless steel) in compliance with the regulation in force. If you use flexible metallic pipes, be careful they do not come in touch with mobile parts or they are not squeezed. Also be careful when the hob is put together with an oven. The connection must be done according to regulation NBN D 5I. Make sure that the gas supply pressure of the appliance obeys the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut G 1/2". All the components shown in the figure have already been assembled in the factory. The appliance, before leaving the factory, has been tested in order to give you the best results. 1 End of shaft with nut 2 Washer 3 Elbow Liquid gas: use the rubber pipe holder. The flexible pipe is prepared for apply when: ­ it can not get hot more than room temperature, higher than 30°C; ­ it is no longer than 1500 mm; ­ it shows no throttles; ­ it is not subject to traction or torsion; ­ it does not get in touch with cutting edges or corners; ­ it can be easily examined in order to check its condition. ­ it does not show cracks, cuts, marks of burnings on the two ends and on its full length; ­ the material is not hardened, but shows its correct elasticity; ­ the fastening clamps are not rusted; ­ expired term is not due. If one or more defects are visible, do not repair the pipe, but replace it. When installation is complete, make sure that the seal of each pipe fitting is correct. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in Technical Data section). Assemble the parts, follow the same procedure backwards. Replace the rating plate (it is near the gas supply pipe) with the one for the new type of gas supply. You can find this plate in the package supplied with the appliance. If the supply gas pressure is changeable or different from the necessary pressure, you must fit an applicable pressure adjuster on the gas supply pipe. [. . . ] ­ Stop the appliance and let it cool down before you clean: limescale rings, water rings, fat stains, shiny metallic discolorations. Use a special cleaner applicable for surface of hob. Clean the appliance with a damp cloth and some detergent. At the end rub the appliance dry with a clean cloth. [. . . ]