User manual AEG-ELECTROLUX EHG30835X

[. . . ] Important Safety Information These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. It is very important that this instruction book should be kept safely for future consultation. If the appliance should be sold or given to another person, please ensure that the booklet goes together with it, so that the new owner can know of the functions of the machine and also be aware of the warnings. About Installation, Cleaning and Maintenance · It is mandatory that all operations required for the installation are carried out by a qualified or competent person, in accordance with existing rules and regulations. [. . . ] 2 Burner minimum diameter 180 mm maximum diameter 260 mm Triple Crown 59 Cleaning and Maintenance Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. This appliance cannot be cleaned with steam or with a steam cleaning machine. General cleaning Wash the enamelled components with warm soapy water. Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. Regularly wipe over the hob top using a soft cloth weel wrung out in warm water to which a little liquid detergent has been added. Avoid the use of the following: - household detergent and bleaches; - impregnated pads unsuitable for non-stick saucepans; - steel wool pads; - bath/sink stain removers. Should the hob top become heavily soiled, it is recommended that a proper cleaning product is used. Fig. 3 The Pan supports The pan supports can be removed from the hob to allow a better cleaning. If the marks are particularly difficult to remove, use common non-abrasive cleaners or specific products. After cleaning, make sure that the pan supports are correctly positioned. Pay attention when replacing the pan supports in order to avoid damaging the hob top. Avoid placing the cast iron pan support on the hob surface in order to avoid damaging or scratching it. The Burners The burner caps and crowns can be removed for cleaning. Wash the burner caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove. After cleaning, be sure to wipe dry with a soft cloth. Periodic Maintenance Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. 60 Instruction for the Installer The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. Avoid installing the appliance in the proximity of inflammable materials (e. g. THE MANUFACTURER WILL NOT ACCEPT LIABILITY, SHOULD ANY OF THE OTHER SAFETY INSTRUCTIONS INCORPORATED IN THIS BOOK OR THE REGULATION IN FORCE BE IGNORED. Technical Data Gas Burners Rating Triple Crown Burner Appliance Class Category Electric supply 4, 0 kW 3 II2H3+ 230 V ~ 50 Hz Natural Gas G20 -20 mbar G 1/2" Hob recess dimensions Length Width 490 mm 270 mm Setting Gas connection Service and Spare Parts Before leaving the factory this appliance was tested and verified by specialized personnel, in order to ensure best performance. Any repair work which needs to be carried out should be done with the utmost care and attention. For this reason we recommend that for any problem you contact the dealer who sold it to you, or our nearest authorized Service Centre, specifying the nature of the problem, the appliance model (Mod. ), the product number (Prod. [. . . ] If there are side walls, or sides of the furniture unit near the hob, the cut out edges must have a minimum distance of 100 mm. TC = Triple Crown burner Fitting the hob to the worktop The hob can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in Fig. To install the hob, proceed as follows: 1) Place the seals supplied with the hob all around the edge of the cut out, taking care that the sealings meet without overlapping. 2) Place the hob in the cut out, taking care that it is centred. [. . . ]