User manual AEG-ELECTROLUX EHG7326X

[. . . ] Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Always insist on genuine spare parts. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Ensure that all control knobs are in the OFF position when not in use. [. . . ] After lighting the flame, keep the knob pushed down for about 5 seconds. This will allow the "thermocouple" (Fig. D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted. Then, check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check the "cap" and "crown" (Fig. To put the flame out, turn the knob to the symbol "l". Always turn the flame down or put it out before taking the pans off the burner. 1 Burner Triple Crown Big (rapid) Medium (semirapid) Small (auxiliary) FO 0204 minimum diameter 180 mm. 160 mm. 3 Maintenance and Cleaning Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. If the marks are particularly difficult to remove, use common non-abrasive cleaners or specific products. 2 6 Electrical connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rating label); 2) check that the power supply is properly earthed in compliance with the current rules; 3) check the socket or the double pole switch used for the electrical connection can be easily reached with the appliance built in the forniture unit. The appliance is supplied with a connection cable. This has to be provided with a proper plug, able to support the load marked on the identification plate. To connect the plug to the cable, follow the recommendation given in Fig. The plug has to be fitted in a proper socket. If connecting the appliance directly to the electric system, it is necessary that you install a double pole switch between the appliance and the electricity supply, with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current rules. The connection cable has to be placed in order that, in each part, it cannot reach a temperature 90 °C. The brown coloured phase cable (fitted in the terminal block contact marked with "L") must always be connected to the network phase. Neutral Replacement of the voltage cable The connection of the voltage cable to the appliance's terminal block is of type "Y". [. . . ] 6 By-pass screw Table 1 : BY-pass diameters Burner Ø By-pass in 1/100 of mm. 28 32 40 56 NOMINAL POWER 3 m /h 0, 381 0, 267 0, 190 0, 095 0, 285 0, 210 0, 186 0, 085 g/h 288 202 144 72 NOMINAL PRESSURE mbar With a thin screwdriver, adjust the by-pass screw (see Fig. If changing from natural gas to LPG, completely tighten clockwise the screw, until a small regular flame is obtained. turning the knob from the maximum position to the minimum position. Finally check the flame does not go out when quickly This procedure can easily be carried out, anyhow the hob has been positioned or built in the working top. [. . . ]