User manual AEG-ELECTROLUX EHGT318CX

[. . . ] Accessible parts of this appliance may become hot when it is in use. Children should be KEPT AWAY until it has cooled. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. [. . . ] · Use only pans or pots with flat bottom. Fig. 1 C D Burner Ultra-Rapid minimum diameter 180 mm. maximum diameter 260 mm. Cleaning and Maintenance Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. This appliance cannot be cleaned with steam or with a steam cleaning machine. Wash the enamelled components with warm soapy water. Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. Carefully wash the stainless steel components with water, then wipe them dry with a soft cloth. If the marks are particularly difficult to remove, use common non-abrasive cleaners or specific products. In models provided with electric ignition, this feature is obtained through a ceramic "candle" and a metal electrode (Fig. Keep these components well clean, to avoid difficult lighting, and check that the burner crown holes (lett. B) are not obstructed. Periodic maintenance Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. To ensure the good operation of the hob and its safety features, it is necessary that the taps are periodically lubricated. The periodic lubrication of the taps must be carried out by qualified personnel, which you must refer to also in case of malfunctioning. 4 Guarantee - After Sales Service Original spare parts This appliance, before leaving the factory, has been tested and studied by many experts and specialists, in order to give you the best results. Any repair work which needs to be carried out should be done with the utmost care and attention. For this reason we reccomend that for any problem you contact the dealer who sold it to you, or our nearest authorized Service Centre, specifying the nature of the problem and the particular model which you own. Original spare parts, certified by the manufacturer of the product and marked with the following sign, can only be found at our approved Technical Assistance Centres and in authorised Spare Parts Shops. 5 Technical Data Gas Burner Rating Ultra-Rapid Burner 4, 0 kW Class 3 Appliance Setting Liquid Gas G30/G31 28 - 30 mbar Gas connection Electric Supply Length Width G 1/2" 220 / 240 V ~ 50 / 60 Hz 270 mm. This appliance complies with the following Directives: 73/23 - 90/683 (Low Voltage Directive); 89/336 (Electromagnetical Compatibility Directive); 90/396 (Gas Appliances) 93/68 (General Directives) and subsequent modifications. Hob recess dimensions Instruction for the Installer The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. Avoid installing the appliance in the proximity of inflammable materials (e. g. section of transit of variuos tubes positioned on the circuit; diameter of eventual connections. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut G 1/2". [. . . ] The traction of the screws is able to trace the sealing, any excess of which can then be easily removed. 490 55 27 0 40÷50 240 550 M 140 591 Fig. 9 If several 30cm hob are to be installed side by side into the same cut out, an assembly kit including a support side bracket and supplementary sealings is available at our After Sales Centres. The relevant installation instructions are supplied within the kit package. a FO 0199 a) sealing Fig. 10 30 9 IN Possibilities for insertion Kitchen unit with door Proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. [. . . ]