User manual AEG-ELECTROLUX EHI331X

[. . . ] This is achieved by turning all the hotplate on full for 3 minuttes without any pots or pans on them. Sincerely ELECTROLUX 2 Important to know Service and repair may only be performed by the distributor, or by a service organization approved by the distributor. Only repair parts deliverde by the distributor may be used. The hob unit is intended for ordinary household cooking purposes. [. . . ] The unit should 4 Operating instructions Switch symbols Switch for regulating the big hot-plates at the rear. Switch for regulating the smal hot-plates at the front. Pilot light Pilot light The pilot light comes on when least one of the hot-plates is switched on. Regulating The hot-plates can be regulated from "112" on the regulation scale. "1" "12" "0" Is lowest heat Is maximum heat The hot-plate is switched off. The hot plates The hob has two quick heating enamelled plates. The enamel makes the plates more durable during normal use and more resistance towards corrosion. 5 Maintenance and cleaning Use the correct cooking utensils Extend the life of the hot-plates and use the electricity to maximum effect by using correct, good quality cooking utensils. The cooking utensils should be designated for use on electric cookers. Ensure theat the hot-plates and the cooking utensils are completely dry before the utensils are placed on the hot-plates. Cleaning of the operating parts and other surfaces All surfaces apart from the hot-plates themselves are cleaned normally with warm water containing washingup liquid, liquid Ajax or similar. The hot plates are cleaned as described on page 5. Never use: Scouring pads, scouring powder, or other harsh cleaning products on the stainless steel parts When using Avoid boiling over. Use larger saucepans or less water. 6 After use Daily cleaning is done with a well wrungout cloth. Extra dirty surfaces can be cleaned by using a plastic sponge with a normal cleaning product. After cleaning, the hotplates should be switched on for a moment until they are fully dry. Clean between the bright metal ring and the hot-plate extra carefully. If you use hot-plate covers, both these and the hot-plates should be completely dry before the covers are replaced. 3. Spillage or stains that remains after the described cleaning (item 1 and 2) can be burnt-off. Switch on the plate to maximum heat for 6-8 minutes. For safety reasons only do this when the plate is under control. Afterwards wipe off the plate with a damp cloth. If you use hot-plate covers, both these and the hot-plates should be completely dry before the covers are replaced. Cleaning of the hot plates Remove solidified food or other spillage from the plates as soon as possible. A dirty plate reduces the heat transmission between the plate and the cooking utensils. For normal maintenance, wipe the plates with a damp sponge or cloth. If necessary add some detergent to the water. [. . . ] If the problem is not with the fuse or relay, do not attempt to correct it yourself. Instead, contact our service network all repairs must be performed by our service personnel. by an alternative service organisation, approved by the distributor. Only spare parts delivered by the distributor may be used. [. . . ]