User manual AEG-ELECTROLUX EHL600K

[. . . ] plastic film, plastic, aluminium) on or near the appliance. How to avoid damage to the appliance · The glass ceramic can be damaged by objects falling onto it. · The edge of the glass ceramic can be damaged by being knocked by the cookware. · Cookware made of cast iron, cast aluminium or with damaged bottoms can scratch the glass ceramic if pushed across the surface. · Objects that melt and things that boil over can burn onto the glass ceramic and should be removed straightaway. [. . . ] · Only let bigger children work on the appliance under supervision. General safety · The appliance may only be installed and connected by trained, registered service engineers. · Built-in appliances may only be used after they have built in to suitable built-in units and work surfaces that meet standards. · In the event of faults with the appliance or damage to the glass ceramic (cracks, scratches or splits), the appliance must be switched off and disconnected from the electrical supply, to prevent the possibility of an electric shock. · Repairs to the appliance must only be carried out by trained registered service engineers. Safety during use · Remove stickers and film from the glass ceramic. · There is the risk of burns from the appliance if used carelessly. 4 Description of the Appliance Cooking surface layout Singlecooking zone 1200W Single cooking zone 1800W Single cooking zone 2300W Residual heat indicator Singlecooking zone 1200W Residual heat indicator The residual heat indicator lights up, as soon as one cooking zone is hot. 1 Caution Risk of burnsthe cooking zones need from residual heat. After being switched off, 2 some time to cool down. Residual heat can be used for melting and keeping food warm. 5 Operating the hob You operate the appliance with the combination appliance's ring switches. The operation and the function of the ring switches is described in the Operating Instructions for the combination appliance. This is a characteristic of all ceramic glass cooking zones and does not impair either the function or the life of the appliance. 3 When a cooking zone is switched on, it may Tips on Cooking and Frying Cookware · You can recognise good cookware from the bottoms of the pans. The bottom should be as thick and flat as possible. · Cookware made of enamelled steel or with aluminium or copper bottoms can leave discolorations on the glass ceramic surface which are difficult or impossible to remove. Energy saving 2 2 2 2 Always place cookware on the cooking zone before it is switched on. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. W 9 Installation Instructions Safety instructions The laws, ordinances, directives and standards in force in the country of use are to be followed (safety regulations, proper recycling in accordance with the regulations, etc. ) Installation may only be carried out by a qualified electrician. The minimum distances to other appliances and units are to be observed. Drawers may only be installed under the appliance with a protective floor. The cut surfaces of the worktop are to be protected against moisture using a suitable sealant. The sealant seals the appliance to the work top with no gap. Avoid installing the appliance next to doors and under windows. Otherwise hot cookware may be knocked off the rings when doors and windows are opened. · Observe electrical safety rules. · Ensure anti-shock protection through correct installation by a qualified electrician. · Rated voltage of the combined appliances must match. 1 Warning! Risk of injury from electrical current. [. . . ] Loose and inappropriate plug and socket connections can lead to overheating of the plug. · Fit plug and socket connections together properly. A device must be provided in the electrical installation which allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm. Suitable isolation devices include line protecting cutouts, fuses (screw type fuses are to be removed from the holder), earth leakage trips and contactors. 1 Important! Sticking on the seal · Clean the worktop around the cut-out area. [. . . ]