User manual AEG-ELECTROLUX EHM9780X

[. . . ] Cooktop OPERATING INSTR UCTIONS OPERATING INSTRUCTIONS Model EHM 9780 35686-3803 SA For your safety This new appliance is easy to use, however, make sure to read this handbook before installing and using it for the first time. In this way you can obtain best use, avoid incorrect operations, use the appliance in complete safety and respect the environment. Installation Appliance installation and connection to the power sup- After using the appliance, make sure all the controls are ply must only be carried out by QUALIFIED PERSONNEL. Before carrying out any operation, make sure the appliance is DISCONNECTED from the power supply. Make sure air can circulate freely around the appliance. in the "CLOSED" or "OFF" position. When using a power socket near this appliance, make sure the cords of any electrical appliances being used do not touch it and are far enough away from its hot parts. Poor ventilation creates a lack of oxygen. Make sure the appliance is fed with the type of gas specified on the special sticker located near the gas connection pipe. The use of a gas cooking appliance produces heat and Advice for safeguarding the environment All the materials used are environmentally friendly and humidity in the room where it is installed. [. . . ] Also, to prevent difficulty in lighting, make sure the flame spreader crown holes are not clogged (B). YES The worktop grates are kept in place by two metal pins located on the back trim of the cooktop. The grates can be removed from the cooktop for better cleaning. Lift the grates, keeping them horizontal as shown in fig. Do not tilt the grates by levering on the pins, as this could damage or break the pins. If damage is noted, disconnect the appliance from the power supply in order to prevent risk of electric shocks, and call the nearest Authorised Technical Assistance Centre. After washing, make sure the grates are correctly positioned as shown in fig. The worktop grates can be placed in a dishwasher. For stubborn stains, use normal non-abrasive detergents or specific products, readily available on the market. DO NOT use scouring pads, steel wool or acids. NO Fig. For correct broiler operation, correctly reposition the screen (see fig. 3). Electric broiler Clean the broiler when it is cold, using absorbent paper or a damp cloth that does not leave strands. Carefully dry the broiler before using it again. It is advisable to occasionally go over it with a little cooking oil or paraffin oil, while it is still warm. products f o r cleaning crockery) which, if not properly rinsed off, can have a corrosive effect or discolour the surface of the top. Do not place materials that could melt, such as aluminium foil, plastic materials, sugar or food with high sugar content, on the top. Fig. If any of these products melts on the vitroceramic top, remove it with a scraper (when the top is still warm). If necessary, complete the cleaning with a specific product. Assistance and spare parts Periodical maintenance Have the state and efficiency of the gas pipe and the pressure regulator (if present) periodically checked. If any anomalies are detected, have the faulty part replaced (and not repaired). To guarantee correct operation and safety, periodically grease the gas adjustment cocks. Periodical lubrication of the cocks must only be carried out by QUALIFIED PERSONNEL; contact only qualified personnel in case of anomalies in appliance operation. Before leaving the factory, the appliances are inspected and prepared by specialised personnel, in order to ensure best operating results. Any subsequent repairs or preparation becoming necessary must be carried out with maximum care and attention. [. . . ] The use of pressure regulators for liquified gases (LPG) is allowed provided they comply with Standard UNI-CIG 7432. Fig. 17 FO 0465 Minimum flame adjustment To adjust the minimum flame, proceed as follows. Light the burner as previously described. Adjust the by-pass pin indicated in fig. [. . . ]