User manual AEG-ELECTROLUX EHO602W

[. . . ] Switching the double ring cooking zone on and off . Switching the power function on and off . 4 4 5 5 5 6 6 6 7 7 7 7 8 9 9 10 11 13 14 14 14 15 15 16 17 18 19 20 21 25 26 27 Installation Instructions . . Installation proud of the work surface . [. . . ] Display p Power Management The cooking zones have a maximum power available to them. If this power range is exceeded by switching on the power function, Power Management reduces the heat setting of another cooking zone. The display for this cooking zone alternates for two minutes between the set heat setting and the maximum possible heat setting. Thereafter the actual heat setting is displayed. Control panel field Select cooking zone Display Pilot light of the cooking zone selected flashes faster The time remaining is displayed After a few seconds the pilot light flashes more slowly. Switching off the acoustic signal Step 1. Control panel field Touch Acoustic signal Acoustic signal to acknowledge. Acoustic signal stops. 12 Safety cut-out Cooking surface If after switching on the cooking surface, a heat setting is not set for a cooking zone within approx. 10 seconds, the cooking surface automatically switches itself off. If one or more sensor fields are covered for longer than approx. by a pan placed upon it, a signal sounds and the cooking surface switches off automatically. If all cooking zones are switched off, the cooking surface automatically switches itself off after approx. 10 seconds. Control panel 3 Moisture (e. g. Wipe the appliance with a damp cloth and a little washing up liquid. Rub the appliance dry using a clean cloth. Removing deposits 1. Place the scraper on the glass ceramic surface at an angle. Remove residues by sliding the blade over the surface. Wipe the appliance with a damp cloth and a little washing up liquid. Rub the appliance dry using a clean cloth. Remove Type of dirt sugar, food containing sugar plastics, tin foil limescale and water rings fat splashes shiny metallic discolorations immediately yes yes ------when the appliance has cooled down ----yes yes yes cleaner for glass ceramic or stainless steel* using a scraper* *Scrapers and cleaners for glass ceramic and stainless steel can be purchased in specialist shops 3 Remove stubborn residuessteel. a cleaner for with glass ceramic or stainless 3 Scratches orbedark stainsdo not however affect on the glass ceramic that cannot removed the functioning of the appliance. 16 What to do if . . . Problem The cooking zones will not switch on or are not functioning Possible cause Remedy More than 10 seconds have passed Switch the appliance on again. since the appliance was switched on The lock is switched on l Switch off the lock (See the section "Locking/unlocking the control panel") The child safety device is switched Deactivate the child safety device on l (See the section "Child safety device") Several sensor fields were touched Only touch one sensor field at the same time The sensor fields are partly covered Remove the cloth or the liquid. by a damp cloth or with liquid Switch the appliance on again. Safety cut-out has been triggered The residual heat indicator is not displaying anything Switch the appliance on again If the cooking zone is supposed to The cooking zone was only on for a be hot, call your local Service Force short time and is therefore not hot Centre. [. . . ] The cut ends should lie in the middle of one side. When you have cut it to length (add a few mm), press the two ends flush up against one another. 20 Assembly 21 22 23 24 Rating Plate 25 Warranty conditions Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions. The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. [. . . ]