User manual AEG-ELECTROLUX EHP740X

[. . . ] Product no: Serienr:. EHP 740 X 949 600 466 GB 28 1 Congratulations from Electrolux Dear Customer, Congratulations with your new Hob. It is important that you become familiar with the functions and features of the Hob. You should therefore read these operating instructions as they will help you get the most out of your new Hob. Pay extra attention to sections marked . [. . . ] Bring a litre of water to the boil in a saucepan with a lid. The cooking zone should be adjusted to the highest setting. The boiling time on the 12 cm cooking zone is approx. The boiling time on the 14 cm cooking zone is approx. The boiling time on the 18 cm cooking zone is approx. 10 min. The hob becomes hot Control button CHEC The fuses keep blowing The cooking zones do not heat sufficiently Panel Controlbutton for operations 24 5 Ceramic glass surface The ceramic glass surface has four cooking zones. When a zone is turned on, it will illuminate at various intervals depending on the heat setting selected. Even at the highest setting the zone is disconnected occasionally to ensure that the surface is not over-heated. The glass is hard, and has been tempered to withstand heat, cold and temperature shocks. But like all glass it is sensitive to impact. Do not stand on the ceramic glass surface. At the front of the ceramic glasssurface in the middle there are four fields. Each field corresponds to a cooking zone. When using a zone, the field concerned will show which CHEC function you are using and the setting at which you have set the zone. means that you do not have to adjust the heat constantly. CHEC control provides the zones with the following functions: Automatic disconnection of "forgotten" zones. Child safety device on zones. Technical data Cell Voltage 230 V Electrical connection 230V - 50Hz Total wattage 7400W Instant heat effect Left front 14/21 cm 1000/2200 W Left Back 18 cm 1800 W Right back 14 cm 1200 W Right front 17/26, 5 cm1400/2200 W This unit is labelled to indicate conformity with the lowvoltage directive (73/23/EEC) and the EMC directive (89/336/EEC). Residual heat indicator When you switch off a zone, an "H" in the display indicates that the zone is still hot. The residual heat indicator will continue to be illuminated until the zone reaches a temperature of approx. 80°C. Unpacking Check that the hob has no faults and is undamaged on delivery. Write the serial number on the cover of these operating instructions to make it easy to find in case of service. Cooking zones There are two single zones and two double zones. Transport damage CHEC control Information about how to use the CHEC control function can be found in the section entitled "Operation instructions". The CHEC control function allows electronic control of the zones. CHEC control enables you to set the heat with great precision, which Any damage from transport which you have not carried out yourself must be reported to the retailer within one week of receipt. You will find the serial number of the 6 23 Electrical installation The electrical connection may only be performed by a qualified electrician/ competent person. [. . . ] Make sure that the ceramic hob has cooled down. Use a ceramic cleaning agent, such as vitroclen. 12 17 Check whether your cooking utensils has level bases by placing the item in question upside down on a work top and positioning a ruler on the base. A curved base, both inwards and outwards, will prolong the cooking time and increase the energy consumption. If the diameter of the base is too small, the energy consumption will increase, and any food boiling over will burn onto the hot cooking zone. [. . . ]