User manual AEG-ELECTROLUX EHS601P

[. . . ] 4 4 5 5 5 6 6 6 7 7 7 7 8 8 9 10 12 13 13 13 14 15 15 16 17 18 19 20 21 42 Installation Instructions . . 3 Operating Instructions 1 Safety instructions 3 Please comply with these instructions. If you do not, any damage resulting is not covered Directives: 73/23/EEC dated 19. 02. 1973 Low Voltage Directive 89/336/EEC dated 03. 05. 1989 EMC Directive inclusive of Amending Directive 92/31/EEC 93/68/EEC dated 22. 07. 1993 CE Marking Directive Safety during use Overheated fat and oil can ignite quickly. frying chips) do not leave the appliance unattended. [. . . ] Control panel Switch on the appliance Touch Touch until the signal sounds Display/Signal l Acoustic signal Appliance switches off. The child safety device is released. 9 Using the timer Function Automatic cut-out Condition a heat setting is set Outcome after the time has elapsed acoustic signal 00 flashes Cooking zone switches off acoustic signal 00 flashes Countdown timer cooking zones not in use 3 If a heat settingcountdownthis cookingcooking is set on zone in addition to a timer, the zone is switched off after the time set has elapsed. 3 If a cookingiszone switched off. off, the timer is switched function set also Selecting a cooking zone Step 1. Touch Control panel once Display Pilot light of the first cooking zone flashes 2. Touch once Pilot light of the second cooking zone flashes 3. Touch once Pilot light of the third cooking zone flashes 4. Touch once Pilot light of the fourth cooking zone flashes 3 If the pilot light is flashing more slowly, the heat setting can be set or modified. 3 If other timer functions are set, after a few seconds the shortest remaining time of all the timer functions is displayed and the corresponding pilot light flashes. 10 Setting the time Step 1. Heat setting V, 1 - 2 3-4 5 6-9 Switches off after 6 hours 5 hours 4 hours 1. 5 hours 12 Tips on cooking and frying 3 Information about acrylamides According to the latest scientific research, intensive browning of food, especially in products containing starch, may present a health risk due to acrylamide. Therefore we recommend cooking at low temperatures and not browning foods too much. Cookware You can recognise good cookware from the bottoms of the pans. The bottom should be as thick and flat as possible. Cookware made of enamelled steel or with aluminium or copper bottoms can leave discolourations on the ceramic glass surface which are difficult or impossible to remove. Energy saving 2 2 2 2 Always place cookware on the cooking zone before it is switched on. If possible, always place lids on the pans. Switch cooking zones off before the end of the cooking time, to take advantage of residual heat. Switch the appliance on again Switch off the lock (See the section "Locking/unlocking the control panel") The lock is switched on l Acoustic signal sounds when appli- The control panel is wholly or partly Remove objects. ance is switched off covered by objects. The residual heat indicator is not displaying anything If the cooking zone is supposed to The cooking zone was only on for a be hot, call your local Service Force short time and is therefore not hot Centre. Let the cooking zone cool down The highest heat setting has the same power as the automatic warm up function 1. Switching off the cooking zone 1. Set the cooking zone using the sensor field Do not place any objects on the control panel The automatic warm up function is There is still residual heat on the not switching itself on cooking zone h The highest heat setting is set The heat setting was set using the sensor field Acoustic signal sounds and appli- The On/Off sensor field has been ance switches itself on and then off covered up, e. g. by a cloth again; after 5 seconds another acoustic signal sounds _ is lit e and number are displayed Overheating protection for the cooking zone has been triggered Electronics fault Switch off the cooking zone. Switch the cooking zone on again Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, e is displayed again, call the customer service department e and minus are displayed Light rays that are too strong on the Briefly shade the control panel, for example with the hand Acoustic control panel, for example bright signal sounds, appliance switches sunlight itself off Switch appliance on (again) 16 If you are unable to remedy the problem by following the above suggestions, please contact your local Service Force Centre. 1 Warning!Repairs to the appliance are only to be carried out by qualified service engineers. 3 If the appliance has been wrongly operated, Considerable danger to the user may result from improper repairs. the visit from the service technician or dealer may not take place free of charge, even during the warranty period. Disposal 2 Packaging material The packaging materials are environmentally friendly and can be recycled. The plastic components are identified by markings, e. g. Please dispose of the packaging materials in the appropriate container at your local waste disposal facilities. 2 Old appliance The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ] The cut ends should lie in the middle of one side. When you have cut it to length (add a few mm), press the two ends flush up against one another. 19 Warranty conditions Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions. The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. [. . . ]